Editing An Effect; Saving An Effect Program - Korg ToneWorks PXR4 Owner's Manual

Operation
[CHAIN 4] This chain is suitable for mic input.
LIMITER
MIC SIM
[INSERT] stereo-in – stereo-out
[MASTER] stereo-in – stereo-out
[FINAL] stereo-in – stereo-out
[CHAIN 5] This chain lets you use modulation and delay
simultaneously.
[CHAIN 6] This chain can be used to adjust the final level
during mixdown.
LIMITER
[CHAIN 7] This chain contains completely independent
modulation effects for L and R.
[CHAIN 8] This chain contains a high-quality reverb.
Selecting the effect type and chain
When editing an effect, you must first select the effect type
and the chain that is the basis of the effect.
To specify the location at which the effect is inserted and
the input/output type, select one of the four types [GUI-
TAR], [INSERT], [MASTER], or [FINAL]. This selection
will determine the chains that can be selected.
To select a chain, select an effect program that uses the
desired chain. ( p.82)
38
GATE MOD DELAY
MOD AMB
EQ GATE
MOD
AMB
For example if you want to edit a program based on
[CHAIN1], select "GUITAR" as the effect type, and select
preset program "50'S." If you want to edit a program
based on [CHAIN5], select "MASTER" as the effect type,
and select preset program "Pan-Echo."
It is not possible to change the chain used by each of the fac-
tory-preset effect programs.

Editing an effect

Select the effect type that you want to start with.
1
Hold down the [SHIFT] key and press the [EFFECT/
TUNER] key to switch "EFFECT ASSIGN" to the
effect type that you want to start with.
Select an effect program.
2
Press the [EFFECT/TUNER] key to enter Effect mode,
and use the dial to select the effect program that you
want to edit.
Select an effect module, and set the parameters.
3
Press the [CURSOR] right key to display the selection
page for the first effect module. If you turn "EffctSel"
to "Off," that module will be off. After making your
selection, press the [CURSOR] right key to move to
the parameter setting page for that module. Parameter
pages exist only for the "effect parameter" indicators
that are lit.
When you finish making these settings, you will be in
the next effect module select page. Make settings in
the same way.
The number of effect modules depends on the effect type.
Also, the editing order of the effect modules may not match
the connection order.