JVC KD-G115 Instructions Manual page 65

KD-G116/KD-G115
Installation/Connection Manual
GET0252-008A
[UT]
ENGLISH
This receiver is designed to operate on 12 V DC, NEGATIVE ground electrical systems. If
your vehicle does not have this system, a voltage inverter is required, which can be purchased
at JVC car audio dealers.
Parts list for installation and connection
The following parts are provided for this receiver.
After checking them, please set them correctly.
A / B
Hard case/Control panel
F G
Washer (ø5) Lock nut (M5)
INSTALLATION (IN-DASH MOUNTING)
The following illustration shows a typical installation. If you have any questions or require
information regarding installation kits, consult your JVC car audio dealer or a company supplying
kits.
• If you are not sure how to install this receiver correctly, have it installed by a qualified
technician.
Removing the receiver
Before removing the receiver, release the rear section.
When using the optional stay /
Fire wall
Dashboard
Install the receiver at an angle of less than 30˚.
TROUBLESHOOTING
• The fuse blows.
* Are the red and black leads connected correctly?
• Power cannot be turned on.
* Is the yellow lead connected?
• No sound from the speakers.
* Is the speaker output lead short-circuited?
• Sound is distorted.
* Is the speaker output lead grounded?
* Are the "–" terminals of L and R speakers grounded in common?
• Noise interfere with sounds.
* Is the rear ground terminal connected to the carʼs chassis using shorter and thicker cords?
• Receiver becomes hot.
* Is the speaker output lead grounded?
* Are the "–" terminals of L and R speakers grounded in common?
• This receiver does not work at all.
* Have you reset your receiver?
C
Sleeve
H
Mounting bolt (M5 x 20 mm)
* When you stand the receiver, be
1
careful not to damage the fuse on
the rear.
When installing the receiver without using the sleeve /
In a Toyota for example, first remove the car radio and install the receiver in its place.
Stay (option)
Screw (option)
Note : When installing the receiver on the mounting bracket, make sure to use the 8 mm-long screws. If longer
D
Trim plate
I
Rubber cushion
Do the required electrical connections.
Insert the two handles, then pull them as illustrated so
that the receiver can be removed.
Flat type screws
*
(M5 x 8 mm)
*
Bracket
Pocket
*
Bracket
screws are used, they could damage the receiver.
1
1004DTSMDTJEIN
EN, CT
E
Power cord
J
Handles
Bend the appropriate tabs to hold the
sleeve firmly in place.
* Not included for this receiver.
Flat type screws
*
(M5 x 8 mm)