Clean; Quality; Set Origin - Ioline FlexJet E User Manual

24 Ioline FlexJet E User Guide
i
Note
Apparel design software usually
refers to the origin as "lower
left" because it is the lower left
corner of a marker. Because the
plot is usually oriented as shown
in Figure 5, it is physically on the
right side of the printer.

Clean

Runs the print heads through a cleaning cycle in the Service Station.
Put the printer in STOP mode and wait until the OK light turns red.
Then press the Clean button. If the carriage is not already parked,
it will return to the Service Station. After auto cleaning, the printer
will react differently when you put it in green light (START) mode,
depending on what it was doing just prior to the cleaning:
Printer state before auto cleaning—e.g.
what the printer is doing just before it is put
in STOP (red light) mode
Printing in START mode (OK light is green) Resumes printing
Idle in START mode (OK light is green)
Idle, in STOP mode (OK light is red)

Quality

Switches between the Best—or dark (600 dpi)—line mode and Draft
mode (300 dpi), which prints lighter and consumes less ink. You can
change line quality while the printer is printing.

Set Origin

The Set Origin key sets the initial origin or starting position for the
marker. It's best to always set a new origin point after cycling power.
To set a new origin, press Start/Stop until the OK light turns red
(STOP mode). Use the Arrow keys to move the carriage so that the
white marker is positioned over the desired starting point. Press the
Set Origin key. The OK light will turn green, indicating the printer
is ready to accept plot files. (See Figure 14.)
Origin Marker
Figure 14. The Set Origin key sets the marker origin point directly below the
top of the white origin marker on the carriage base—located on the right side.
Printer reaction when put in
START mode after auto cleaning
Stays parked and capped.
Stays parked and capped.