TRANSCEIVER FS-2570T
The following screen appears.
MMSI SET
MMSI CLEAR
ALL CLEAR
3. Enter the password referring to appropriate FURUNO INFORMATION. Regulations
prohibit the release of the password to users.
4. Rotate the ENTER knob to select MMSI SET and press the ENTER knob.
5. Enter MMSI (Own ship's ID).
6. Turn off the power and then turn it on again.
7. Do the initialization as follows.
1) Press the SET UP key to show the Set up menu.
2) Enter the password.
3) Select LOAD DEFAULT and press the ENTER knob.
4) Select Yes and press the ENTER knob.
5) Press the CANCEL key to return to the menu screen.
6) Select MEM CLR from the menu screen and press the ENTER knob.
7) Select LOAD DEFAULT and press the ENTER knob.
8) Select Yes and press the ENTER knob.
9) Press the CANCEL key to return to the menu screen.
8. Turn off the power at the control unit.
Note: If your system has two control units, do the steps 6) to 9) in step 7 from the second
control unit.
3-2
RESET SWITCH
S1
05P0732B
T-CPU BOARD