Epson C63, C64, C83, C84 Service Manual page 44

EPSON Stylus C63/64/83/84
Table 3-2. Lubrication point
No. Lubrication type/point
<Lubrication point>
• Lubricate G-58 along CR guide parts of
[FRAME MAIN] on 4 position by using
Frame main lubrication fixture. (Figure
3-7)
<Lubrication type>
4
• G-58
<Lubrication amount>
• Quantity for each position is 100mg.
• Length of G-58 spread is 350mm. (From
Paper Guide Front to Slider Cap hook)
• Wide of G-58 spread is 2mm.
<Lubrication point>
• Lubricate [GROUNDING SPRING
ROLLER PF] touch side to of [ROLLER
PF]. (Refer to Figure 3-8.)
5
<Lubrication type>
• G-58
<Lubrication amount>
• F1 x 0.5F of [ROLLER PF].
<Lubrication point>
• Lubricate G-26 to center of cam [LEVER
PAPER RETURN]. (Refer to Figure 3-9.)
<Lubrication type>
6
• G-26
<Lubrication amount>
• F1 x 1mm
Maintenance
Remarks
• Use clean Cotton stick to avoid
dirt on G-58.
• Be careful when rubbing the
grease, don't drop or dirt the
grease to other parts.
• Don't spread G-58 to other parts.
• G-58 must spread out and touch
to [ROLLER PF] and
[GRANDING SPRING PF].
• Make sure G-26 doesn't spread
to other parts.
Overview
Table 3-2. Lubrication point
No. Lubrication type/point
<Lubrication point>
• Lubricate G-58 around small circle of
[PULLEY EJECT DRIVE ; B]. (Refer to
Figure 3-10.)
7
<Lubrication type>
• G-58
<Lubrication amount>
• F1 mm x 2 position
<Lubrication point>
• Lubricate G-58 onto U-shape of
[HOLDER IDLE ROLLER] on 2
positions. (Refer to Figure 3-11.)
8
<Lubrication type>
• G-58
<Lubrication amount>
• F1 x 1 circle
G-58 Ø1mm X 2
Figure 3-4. Lubrication point 1
Revision A
Remarks
• Don't spread G-58 to other parts.
• G-58 shouldn't spread out to
[MOTER ASSY PF] Pinion
surface, and [TIMING BELT].
44