Black Box Agility Quick Start

Using the Agility and iPATH rack mount
1 Install the empty rack mount tray into your 19" rack frame and fully secure it.
2 Place Agility or iPATH units into each side of the rack mount tray so that their rear panels
butt up against the small pegs located on each of the side walls.
3 Locate the supplied thumbscrew and spacer.
4 Insert the thumbscrew through the spacer; then insert into the small hole at the end of the
center divider (A).
5 Gently tighten the thumbscrew so that the spacer engages with the inner edges
of the two units and holds them in place (B).
6 Place the power adapters in the rear section of the rack mount tray
and connect them to their respective units.
7 Make all other necessary connections to the units.
(A) (B)
Agility and iPATH rack mount
1
2
1
2
Quick Start
See overleaf if installing a single iPATH unit.