Visual Guidance Settings - Clarion NX501 Owner's Manual & Installation Manual

Button

4.3.6 Visual guidance settings

Settings related to guidance on the map screen can be adjusted here.
81 NX501/NZ501 English
Switch between daytime and night color modes or let the software switch
between the two modes automatically a few minutes before sunrise and a few
minutes after sunset.
Select the color scheme used in daytime mode.
Select the color scheme used in night mode.
Replace the default position marker to one of the 3D vehicle models. You can
select separate icons for different vehicle types selected for route planning.
Separate icons can be used for car, pedestrian and the other vehicles.
Show or suppress 3D landmarks, 3D artistic or block representations of
prominent or well-known objects.
Show or suppress 3D city models, 3D artistic or block representation of full city
building data containing actual building size and position on the map.
Turn on or off track log saving, that is, saving the sequence of the locations your
journeys go through.
Select which Places to show on the map while navigating. Too many Places
make the map crowded so it is a good idea too keep as few of them on the map
as possible. For this, you have the possibility to save different Place visibility sets.
You have the following possibilities:
x
Tap the checkbox to show or hide the Place category.
x
Tap the name of the Place category to open the list of its subcategories.
x
Tap
previously saved one. Here you can also revert to the default visibility
settings.
The data fields in the corner of the Map screen can be customized. Tap this
button and select the values you want to see. The values can be different when
you navigate a route from when you are just cruising without a given destination.
You can select general trip data like your current speed or the altitude, or route
data related to your final destination or the next waypoint on your route.
Whenever adequate information is available, lane information similar to the real
ones on road signs above the road is displayed at the top of the map. You can
turn this feature on or off.
Description
to save the current Place visibility set or to load a