Char-Broil COMMERCIAL 463268008 Product Manual page 20

Under sideburner shelf, attach sideburner ignitor wire to electrode (A). Place burner cap onto sideburner. Attach sideburner
11
cap clip (B). Place sideburner grate onto sideburner shelf, aligning grate legs with holes in shelf.
A
Sideburner Ignitor Wire
B
Sideburner
cap clip
First, attach tank heat shield and shield extension together with two #8-32x3/8" screws, 4mm flat washers, 4mm lock
12
washers and #8-32 hex nuts. Inside of cart, insert rear shield tabs into two left slots between upper and lower back panels.
Attach left and center front shield tabs under front brace with #8x3/8" self-tapping screws. Insert left and right grease tray
rails into slots beneath grease tray opening in upper back panel. Attach left rail to brace, with a #8x3/8" self-tapping screw.
Attach right rail and right front shield extension tab together under front brace with a #8x3/8" self-tapping screw.
#8-32x3/8"
Screw
Tank heat shield
Some components not shown for
illustration purposes.
20 • 463268008
Sideburner grate
Burner cap
Tank heat shield extension
4mm Flat washer
4mm Lock washer
#8-32 Hex nut
Grease tray opening
Front brace
#8x3/8" self-
tapping screw
Left grease tray rail
Right grease tray rail