Adjusting The Eyepiece; Operational Summary; Liquid Crystal Display (Lcd) Indicators - Bushnell Tour V2 Owner's Manual

ADJUSTING THE EYEPIECE

Your TOUR V2 is constructed with an adjustable eyepiece (+/- 2 Diopter Adjustment) that allows one
to focus the LCD display relative to the image. Simply rotate the eyepiece until the reticle and object
distanced to are in focus to your eye.

OPERATIONAL SUMMARY

While looking through the 5x eyepiece, depress the power button once to activate the in-view Liquid
Crystal Display (LCD). Place the aiming circle (located in the center of the field of view) upon a target
at least 5 yards away, depress and hold the power button down until the range reading is displayed
near the bottom of the in-view display. Crosshairs surrounding the aiming circle indicate that the laser is
being transmitted. Once a range has been acquired, you can release the power button. The crosshairs
surrounding the aiming circle will disappear once the power button has been released (i.e. the laser is no
longer being transmitted). Note: Once activated, the LCD will remain active and display the last distance
measurement for 30 seconds. You can depress the power button again at any time to distance to a new
target. As with any laser device, it is not recommended to directly view the emissions for long periods
of time with magnified lenses. The maximum time the laser is transmitted (fired) is 10 seconds. To re-fire,
press the button down again.

LIQUID CRYSTAL DISPLAY (LCD) INDICATORS

Your TOUR V2 WITH PINSEEKER's LCD incorporates illuminated indicators that advise the user unit of
measure, when the laser is actively firing, when a target has been acquired, and targeting modes. A
summary of these features is presented below:
7
201930_33 Tour V2 6LIM.indd 7 8/26/08 2:40:23 PM