GE VG2052 User Manual page 55

Ge vg2052: user guide
Table of Contents

Advertisement

APPENDIX: REFERENCE
Time counter not working or time counter not working in search
modes
The time counter does not advance during unrecorded portions of
tape. When an unrecorded segment of tape is encountered, the
time counter will hold its count until recorded material is detected
again.
A minus (–) will appear in front of the time if you rewind the tape
farther back than a counter reading of 0:00:00.
The time counter disappears during search; this is normal.
Will not record or play
Check to make sure there is a tape in the VCR.
Try ejecting and reinserting the cassette.
Check to make sure the tape is not broken.
Check to make sure the VCR is not in pause mode. Press PAUSE or
PLAY to return to normal playback.
Check the ProTect Plus™ feature.
Rewind does not operate
Check to make sure the tape is not already rewound.
Timer recording not made or wrong program recorded
Check to make sure the cable box or satellite receiver was turned
on when recording was to begin.
Check to make sure the program was entered correctly (wrong
channel or times).
Power interruption. Reset the clock.
Check to see if time and date are correct – including AM/PM.
Check to make sure the program did not exceed the tape's length or
the tape was not rewound beforehand.
Check to make sure the VCR was turned off at the time recording
was to start.
Check to make sure there was a tape in the VCR and the cassette's
safety tab was intact.
VCR ejects cassette when the end of the tape is reached during a
timer recording.
Will not record
Check to make sure the safety tab is intact.
Check to make sure the VCR is not in the line mode. Press INPUT
on the remote.
53

Advertisement

Table of Contents
loading

Table of Contents