GE Profile PP932SMSS Dimensions And Installation Information

PP932SM
GE Profile 30" Built-In CleanDesign Electric Cooktop
™
Dimensions and Installation Information (in inches)
Note: Check local codes for required breaker size
†
KW Rating
Important: Requires a 5" free area between
240V 8.6
the bottom of the cooktop to any combustible
208V
6.5 material, i.e., shelving. Free area not required
when installing wall oven underneath cooktop.
Breaker Size
Refer to installation instructions. Requires a
240V 40 Amps
15" minimum from cooktop to adjacent
†
overhead cabinets. Units are furnished with
208V 40 Amps
†
a 48" flexible armored cable.
Note: 30" Ribbon cooktops are approved for use over select GE 27"
and GE 30" Single Wall Ovens and Warming Drawers. Refer to cooktop and
wall oven/warming drawer installation instructions packed with product
for current -dimensional data. If installed with a GE Profile
Downdraft System, consult both the cooktop and downdraft installation
instructions packed with product before installing. Cooktop gas/electric
supply may need to be re-routed to install downdraft. Consult cabinet and
countertop manufacturer's specs for flush mount installation prior to
install. Before installing, consult installation instructions packed with
product for current dimensional data.
Filler Trim Kit: When replacing an old GE 30" cooktop (with larger opening)
use the following one-piece trim kit to fill in the over-size hole. Available at
additional cost. JXTR32W (True White) JXTR32B (Black glass) JXTR32C (True
Bisque)
For answers to your Monogram, ®
GE appliance questions, visit our website at
®
ge.com or call GE Answer Center
800.626.2000.
Telescopic
™
GE Profile ™ or
service,
®
21-1/2
29-7/8
Cooktop
19-5/8
28-1/2
2-1/2**
Required
* Depth of unit at conduit connection location (rear) is
6-1/2" on models PP980/950 and 4-5/8" on models
PHP900/PP975/972/962/945/942/932/912,
JP655/356/346.
**Raised bull nose countertops may require up to
3/8" additional clearance to prevent interference
with curved front.
30_ss_cktp_install.eps
13" MAX.
depth
3-1/4*
30" MIN. to
unprotected
cabinet
15" MIN.
to cabinet
1-3/4" to
rear wall
1-1/2" MIN.
clearance to
side wall
from cut-out
Electrical junction box 16" MIN.
below countertop
Specification Revised 12/07
1-1/2" MIN.
clearance to
side wall
from cut-out
Cut should
not interfere
with cabinet
structure
at front
Listed by
Underwriters
Laboratories
220583