Table of Contents
Advertisement
Quick Links
Translation of the operating instructions for the compressed air manual
belt sander
HB 12 S
HBH 200
HB 20
HB 15-1
HB 15-12
HB 3
A copy of this manual must be given to all personnel working with this tool.
Schmid & Wezel GmbH
Maschinenfabrik
Maybachstrasse 2
D - 75433 Maulbronn
Tel.: 07043 1020
Fax: 07043 10278
E-mail: biax-verkauf@biax.de
www.biax.de
001580313 – V12.2021
Advertisement
Table of Contents
Related Manuals for BIAX HB 12 S
Summary of Contents for BIAX HB 12 S
- Page 1 Translation of the operating instructions for the compressed air manual belt sander HB 12 S HBH 200 HB 20 HB 15-1 HB 15-12 HB 3 A copy of this manual must be given to all personnel working with this tool.
- Page 2 Translation of the operating instructions Technical data l/min watt m/s² dB(A) dB(A) dB(C) Type = 73 = 84 = 89.9 HB 12 S pCpeak R1/8” 20,000 < 2.5 K=0.05 150123105 pCpeak = 75 = 86 = 93.4 HB 15-1 pCpeak R1/8”...
-
Page 3: General Notes
In-house health and safety regulations must be observed. Safety instructions Intended use The BIAX compressed air manual belt sander is used The noise level specified can be • exceeded during some working surface processes. -
Page 4: Connection And Start-Up
The flow pressure of 6 bar must never be exceeded switched off. during operation. Operate the BIAX compressed air manual belt sander If the air supply is interrupted, switch off the machine only with clean, water-free air. To do this, connect the immediately. -
Page 5: Switching On And Off
Please note the following points before mounting: With the HB 12 S, make sure that the spring is located between the clamping arm (H) and the sanding arm. A washer must be located under the knurled screw (L) (see Fig. - Page 6 Fig. 4). Belt running direction Fig. 5: Belt change HB 15-1 / HB 20 Fig. 3: Belt change HB 12 S During assembly, place the sanding belt around the sanding arm roller (N), press the sanding arm together and place the sanding belt over the drive roller (M) (see During assembly, place the sanding belt around the drive Fig.
-
Page 7: Maintenance
Remove any condensation and top up with BIAX special oil if necessary. This prevents damage to ball bearings, motor parts and the rotor caused by dirt or rust particles. -
Page 8: Special Accessories
Compressed air manual belt sander Translation of the operating instructions Accessories The delivery includes the manual belt sander and a key for adjusting the sanding arm. Special accessories Compressed air fittings, one-hand couplings with male thread or hose connection, filter pressure reducers, silencers, hose balancers, hose units, collets, spiral hoses and workbench equipment can be found in our catalogue.