To find the beginning of a track –
Automatic Music Sensor (AMS)
You can locate the beginning of a track
while the track is playing or while it is in
pause mode.
To locate the beginning of the current or
preceding track, press =0 (or = on
the remote) until you find the desired track.
To locate the beginning of the succeeding
track, press )+ (or + on the remote)
until you find the desired track.
To find a point in a track
You can find a particular point in a track
while playing or pausing a CD. Use the
buttons on the player to operate this
feature. This operation is not possible with
the remote.
To Search
Operation
Hold down )+
Forward while
listening
and release it at the
desired point.
Hold down =0
Backwards
GB
while listening
and release it at the
7
desired point.
Hold down )+ or
Quickly
=0 during pause
without
listening while
and release it at the
checking the
disired point.
playing time in
the display
Note
If the CD reaches the end while you are
searching quickly without listening,
"OVER"appears in the display. Press =0
(= on the remote) to go back.
To check the total number of tracks
and total playing time
Press DISPLAY on the remote while the
player is in stop mode.
The indications appear for a few seconds.
Total number
of tracks
1 2
5
4
0 5
Total playing
time
To check the remaining time
Press DISPLAY on the remote repeatedly
while playing a CD.
Each time you press DISPLAY, the display
changes as follows.
Current track number and
Z
playing time
v
Current track number and
remaining time on the track
v
Remaining time on the CD
Chapter 2: the CD Player