Page 1
3-IN-1 STUD CENTER FINDING, METAL AND AC LIVE WIRE DETECTOR CT2129 Ref no. TH210 INSTRUCTION MANUAL IMPORTANT: These instructions accompanying the product are the original instructions. This document is part of the product, keep it for the life of the product passing it on to any subsequent holder of the product.
In case of alteration of the machine, not agreed upon by us, this declaration will lose its validity. Product description: 3-IN-1 STUD CENTER FINDING, METAL AND AC LIVE WIRE DETECTOR Model: CT2129 (Ref no. TH210) Applicable EU Directives: EC Directive of Electromagnetic Compatibility 2014/30/EU Harmonized standards EN 61326-1:2013 20 Station Road, Rowley Regis, West Midlands, B65 0JU.U.K.
1. SPECIFICATION Detects wood and metal stud up to 1-1/2" (38mm) Detects metal rebar up to 3" (76mm) Detects AC live wire up to 3" (76mm) Operating temperature / humidity: 0 Cto 40 Power supply: DC 9V (battery included) Warning: Wear approved safety glasses and ear defenders. 2.
4. UNPACKING AND CHECKING Carefully remove the product from the packaging and examine it for any sign of damage that may have happened during shipping. Lay the contents out and check them against the parts shown below. If any part is damaged or missing; please contact the seller and do not attempt to use the product .
Page 5
Power: Depress and hold in the Scan button continuously while in use. Calibration: Place unit flat on wall. Press and hold the Scan button. Do not move the unit until calibration is complete (1-2 seconds). When calibration is complete, the unit will sound a short beep and the bars will be cleared. Operation: Move the unit slowly, while keeping it flat against the wall.
slowly slide the unit across the surface. Mark the spot where the display bars peak and a steady tone sounds. Continue in the same direction until display bars reduce. Reverse direction and mark the spot where the display bars peak from that direction.