Virus Related; System Configuration - Acer Aspire M5810 Service Manual

Message
Displayed
6th Slave Drive The IDE/ATAPI device configured as Slave in the 6th IDE controller failed an ATAPI
- ATAPI compatibility test. This message is typically displayed when the BIOS is trying to detect and
Incompatible configure IDE/ATAPI devices in POST.
S.M.A.R.T. The BIOS tried to send a S.M.A.R.T. message to a hard disk, but the command transaction
Capable but failed.
Command
This message can be reported by an ATAPI device using the S.M.A.R.T. error reporting
Failed
standard. S.M.A.R.T. failure messages may indicate the need to replace the hard disk.
S.M.A.R.T. The BIOS tried to send a S.M.A.R.T. message to a hard disk, but the command transaction
Command failed.
Failed
This message can be reported by an ATAPI device using the S.M.A.R.T. error reporting
standard. S.M.A.R.T. failure messages may indicate the need to replace the hard disk.
S.M.A.R.T. A S.M.A.R.T. capable hard disk sends this message when it detects an imminent failure.
Status BAD,
This message can be reported by an ATAPI device using the S.M.A.R.T. error reporting
Backup and
standard. S.M.A.R.T. failure messages may indicate the need to replace the hard disk.
Replace
S.M.A.R.T. A S.M.A.R.T. capable hard disk sends this message when it detects an imminent failure.
Capable and
This message can be reported by an ATAPI device using the S.M.A.R.T. error reporting
Status BAD
standard. S.M.A.R.T. failure messages may indicate the need to replace the hard disk.

Virus Related

Message
Displayed
BootSector The BIOS has detected software attempting to write to a drive??s boot sector. This is
Write flagged as possible virus activity. This message will only be displayed if Virus Detection is
enabled in AMIBIOS setup.
VIRUS: If the BIOS detects possible virus activity, it will prompt the user. This message will only be
Continue (Y/ displayed if Virus Detection is enabled in AMIBIOS setup.
N)?

System Configuration

Message
Displayed
DMA-1 Error Error initializing primary DMA controller. This is a fatal error, often indication a problem with
system hardware
DMA-2 Error
Error initializing secondary DMA controller. This is a fatal error, often indication a problem
with system hardware.
DMA POST error while trying to initialize the DMA controller. This is a fatal error, often indication
Controller a problem with system hardware.
Error
Checking BIOS could not write to the NVRAM block. This message appears when the FLASH part is
NVRAM..Upda write-protected or if there is no FLASH part (System uses a PROM or EPROM).
te Failed
49
Description
Description
Description
Chapter 4