Panasonic FV-07VF1 Installation Instructions Manual
Whisperfit™ 70 cfm low profile ceiling mounted fan fv-07vf1 operating manual
Hide thumbs
Also See for FV-07VF1:
- Installation instructions manual (14 pages) ,
- Instructions d'installation (8 pages) ,
- Notice de montage (5 pages)
Advertisement
Quick Links
INSTALLATION INSTRUCTIONS
Housing Can
FV-05-11VFA
Applicable to Models: FV-05VF1, FV-07VF1, FV-09VF1, FV-11VF1
Please read these instructions carefully before attempting to install,
operate or service the Panasonic Ventilating Fan. Failure to comply
with instructions could result in personal injury and/or property
damage. Please retain this booklet for future reference.
Table of Contents
II
Installation
III
Installation
SUPPLEMENTARY
(For Contractor Pack)
READ AND SAVE THESE INSTRUCTIOINS.
( Wooden Header )
( In Existing Construction )
Motor/Grille Assembly
FV-05VFB, FV-07VFB, FV-09VFB, FV-11VFB
2
3
3
3
4-5
6
6-7
7
7
Advertisement
Related Manuals for Panasonic FV-07VF1
Summary of Contents for Panasonic FV-07VF1
-
Page 1: Table Of Contents
READ AND SAVE THESE INSTRUCTIOINS. Please read these instructions carefully before attempting to install, operate or service the Panasonic Ventilating Fan. Failure to comply with instructions could result in personal injury and/or property damage. Please retain this booklet for future reference. -
Page 2: General Safety Information
GENERAL SAFETY INFORMATION 1. Do not install this ventilation fan where air temperature may exceed 40 C (104 F). 2. Make sure that the electric service supply voltage is 120V, 60 Hz. 3. Follow all local electrical and safety codes, as well as the National Electrical Code (NEC) and the Occupation Safety and Health Act (OSHA). -
Page 3: Unpacking
UNPACKING Unpack and carefully remove unit from carton. Refer to the following Supplied Accessories list to verify that all parts are present. SUPPLIED ACCESSORIES SUPPLIED ACCESSORIES (A) For Motor/Grille Assembly of model: FV-05/07/09/11VFB Part name (B) For Housing Can of model: FV-05-11VFA Part name Long screw (ST4.2X20) -
Page 4: Installation I ( Joist Mounting )
INSTALLATION INSTALLATION JOIST MOUNTING JOIST MOUNTING 1. Remove the tape from damper and adaptor before installation. (Fig. 1) 2. Remove adaptor from body and secure adaptor to ceiling joists using long screws. (Fig. 2) Keep the distance B (21.6mm, 7/8 inch) for the thickness of ceiling board. - Page 5 INSTALLATION INSTALLATION JOIST MOUNTING CONTINUED JOIST MOUNTING CONTINUED 4. Install a circular duct (using 4 inches duct or 3 inches duct) and secure it with duct tape or clamp as shown in Fig. 4. 5. Insert fan body into ceiling. (Fig. 5) 6.
- Page 6 INSTALLATION INSTALLATION II ( II ( 1. Remove the tape from damper and adaptor before installation. (Fig. 1) 2. Secure the fan body to the adaptor by using one thumb screw as shown in Fig. 6 3. Install header between ceiling joists using nails or screws. Then install the fan body and secure with screws.
-
Page 7: Practical Guide To Installation
(Fig. 13) Loose fill or batt insulation can be placed directly over the fan housing in the attic. Panasonic fans and fan/light combination units do not create excessive heat that is a common problem with recessed light fixtures or some competitors' fan/light combinations. - Page 8 PANASONIC CONSUMER ELECTRONICS COMPANY Division of Panasonic Corporation of North America, One Panasonic Way, Secaucus, NJ 07094 PANASONIC CANADA INC. 5770 Ambler Driver, Mississauga, ON L4W 2T3 www.panasonic.com X0806-4047 07VFA4020D...