Connection - Panasonic TH-50PX600U Operating Instructions Manual

Connection

Watching TV
VHF/UHF Antenna
or
Cable TV
or
F-Type
Antenna
CableCARD™ Adapter
S-Video
OUT
ANT IN
Video
ANT OUT OUT
L
Audio
OUT
R
Video
Video recorder
IN
with TV Tuner
L
DVD Recorder /
Audio
VCR
IN
R
Note
•
All cables and external equipment shown in this book are not supplied with the TV.
•
For additional assistance, visit us at : www.panasonic.com
www.panasonic.ca
•
The S Video input will override the composite video signal when S Video cable is connected.
Connect either S Video cable or Video cable.
•
When receiving digital channel signals, all digital formats are down-converted to composite NTSC video to be
output through the PROG.OUT terminals.
•
Some programs contain a copyright protection signal to prevent VCR recording.
•
When the copyright protection program is displayed, do not connect the other TV monitor through a VCR. Video
signals fed through VCRs may be affected by copyright protection systems and the picture will be distorted on the
other TV monitor.
•
Set the TV channel to CH3 or CH4 for using Cable Box Connection.
10
Back of the unit
Fastener
•
To unfasten
AC cord
(Connect after all the
other connections.)
S-Video signals have
priority.
To record TV shows
CableCARD
CableCARD TM allows you to tune digital and high definition cable channels through the cable antenna.
Consult your cable company on the availability of CableCARD
1. Connect the cable antenna to ANT connector.
2. Turn the TV on (see page 17).
3. Set the input mode to TV (see page 29).
TM
4. Insert the CableCARD (with upper side facing you) as far as
it will go into the CableCARD TM slot on the back of the TV.
Follow the messages displayed on the screen.
Note
•
If you experience front panel control or remote control function hang-up when using CableCARD
TV and plug it back on and try the controls again. If this condition persists, please call Panasonic Customer Call
Center for further instructions.
•
Do not insert a PCMCIA card into CableCARD TM slot.
Cable Binding Instructions
Fixing connection cables and AC cord
Example of "connection cable routing"
AC cord
Connect power
plug to the socket
of the main body.
Cable
Fix the AC cord in
clamper
Cable clamper.
Band
Attach the bands
Fastening band
Band
Insert the spigot on the two bands into the
pedestal.
Fastening
push the tip of the band in the
direction indicated by the arrow.
Loosening
While pressing down on the
tab, gently push the tip of the
band in the direction indicated
by the arrow.
TM Connection
TM .
Back of the TV
Insert mark (e.g.)
Upper side of the card facing you
( The CableCARD TM design varies )
depending on the manufacturer.
TM , unplug the
How to fix: How to release:
Fix by pushing Pull up while
in till a clicking drawing the
sound is heard. knob.
•
Do not bundle the RF cable and AC cord together
(could cause distorted image).
•
Fix cables with Cable clampers as necessary.
•
When using the optional accessory, follow the
option's assembly manual to fix cables.
Attaching the Cable clampers
Snap shut
Snap open
Remove from the TV unit
Push both side
hooks and pull out
Tab
11