Page 1
User’s Guide LCD Computer Monitor ake sure to read the before using this product. Keep the User's Guide(CD) in an accessible place for furture reference. ave the model and serial number ready when calling for support.
Page 2
On Safety Use only the power cord supplied with the unit. In case you use another power cord, make sure that it is certified by the applicable national standards if not being provided by the supplier. If the power cable is faulty in any way, please contact the manufacturer or the nearest authorized repair service provider for a replacement.
Page 3
On Installation Do not allow anything to rest upon or roll over the power cord, and do not place the display where the power cord is subject to damage. Do not use this display near water such as near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool.
Connecting the stand Place the monitor with its front facing downward on a soft cloth. Assemble the Stand Body into the product in the correct direction as shown in the picture. Make sure you push it until you hear it “click”. Assemble the Stand Base(Front, Rear) into the Stand Body in the correct direction.
Positioning your display Adjust the position of the panel in various ways for maximum comfort. -5˚~20˚ Warning: When adjusting the angle of the screen, do not put your finger(s) in between the head of the monitor and the stand body . You can hurt your finger(s).
Using the Computer Place the monitor in a convenient, well-ventilated location near your computer. Connect the signal cable. When attached, tighten the thumbscrews to secure the connection. Connect the power cord into a proper power outlet that is easily accessible and close to the display.
Screen Adjustment Allow the display to stabilize for at least 30 minutes before making image adjustments. To make adjustments in the On Screen Display, follow these steps: Press the MENU Button, then the main menu of the OSD appears. To access a control, use the becomes highlighted, press the AUTO/SET Button.
Page 12
The order of icons may differ depending on the model (A11~A15).
Page 13
OSD (On Screen Display) menu languages on the monitor may differ from the manual.
Page 16
Main menu Sub menu Description WIDE * 4:3 : Depending on the input video signal ratio, it is automatically changed to an optimized screen ratio. (The 1280X1024 input signal is changed to 5:4 ratio and 1024X768 to 4:3.) 1280x1024 5 : 4 1152x864 4 : 3 1024x768...
Display image is incorrect Important Check Control Panel --> Display --> Settings and see if the frequency or the resolution were changed. If yes, readjust the video card to the recommend resolution. Reasons for Recommending Optimal Resolution : The aspect ratio is 16:10. If the input resolution is not 16:10 (for instance, 16:9, 5:4, 4:3), you might encounter problems such as blurred letters, blurry screen, cut-off screen display or tilted screen.
Page 19
Display image is incorrect Have you installed the display driver?
Page 20
Information in this document is subject to change without notice.