Electrical Connection - Cannon CHICHESTER 10572G Use And Installation Instructions

Cannon cooker use and installation instructions

Hide thumbs

Table Of Contents

Table of Contents

WARNING –

THIS APPLIANCE MUST BE EARTHED.

CONNECT TO A 230-240V A.C. SUPPLY ONLY.

Connection to the electricity supply should be made via a properly earthed, readily accessible

wall socket which is adjacent to but not directly above, and not more than 1.25m away from the

appliance and capable of electrical isolation.

The mains lead should be routed such that it cannot touch hot parts of the cooker i.e. the back

panel above a height of 650mm from the floor.

Should this plug not fit the socket outlet in your home it should be cut off and replaced with a

suitable plug as outlined below.

NOTE: The removed plug cannot be used for any other appliance and should therefore be

properly disposed of and not left where children might find it and plug it into a supply socket –

with the obvious consequent danger.

IF THE FITTED PLUG IS REMOVED

The flexible mains lead must be correctly connected as below to a three pin plug of not less

than 13 amp capacity. If a B.S. 1363 fused plug is used, it must be fitted with a 3 amp fuse which

is approved to B.S. 1362.

IMPORTANT: The wires in the mains lead fitted to this

appliance are coloured in

accordance with the following code:

GREEN AND YELLOW

BLUE

BROWN

As the colours of the wires in the mains lead of this appliance may not correspond with the

coloured markings identifying the terminals in your plug, proceed as follows:– The wire which is

coloured green and yellow must be connected to the terminal in the plug which is marked with

the letter E or by the earth symbol

coloured blue must be connected to the terminal which is marked with the N or coloured black.

The wire which is coloured brown must be connected to the terminal which is marked with the

letter L or coloured red. When wiring the plug, ensure that all strands of wire are securely

retained in each terminal. Do not forget to tighten the mains lead clamp on the plug. As the

appliance must be earthed, do not use 2-pin sockets outlets, if you are in doubt, consult a

qualified electrician.

Should the mains lead ever require replacement, it is essential that this operation be carried out

by a qualified electrician and should only be replaced with a flexible cord of the same size i.e.

0.75mm

cross sectional area and temperature rating of 85˚ C e.g. heat resisting PVC, available

from our parts department (see Back Cover).

IF A MOULDED PLUG IS FITTED

In the event of replacing a fuse in the plug supplied a 3 amp ASTA approved fuse to BS1362

must be fitted.

NOTE: The fuse cover must be refitted when changing the fuse. In the event of losing the fuse

cover the plug must not be used until a replacement fuse cover has been obtained and fitted. A

new fuse cover can be obtained from your local Electricity Board. The colour of the correct

replacement fuse cover is that of the coloured marks or inserts in the base of the plug.

Make sure that the cable does not become trapped when pushing the cooker into position.