Instructions - Frigidaire FDBB2865FC0 Use & Care Manual

Precision direct wash system
Hide thumbs Also See for FDBB2865FC0:
Table of Contents

Advertisement

Operating Instructions
Status Indicator Lights
The SENSING light (some models) comes on at
the beginning of the selected cycle and will remain
on until the end of the sensing sequence.
The WASHING light (some models) comes on at
the beginning of cycle and remains on until the end
of the main wash.
The DRYING light (some models) indicates the
drying portion of the cycle. The light will come on
when either drying option is selected.
When the SANITIZE option is selected, the
SANITIZED light will glow when the SANITIZE
cycle is finished. If the dishwasher did not properly
sanitize the dishes, the light will not come on. This
can happen if the cycle is interrupted. The light will
remain on until the door is opened.
The RINSING AGENT LOW light (some models)
comes on at the end of a cleaning cycle when the
rinse agent reservoir is low. The light will remain on
through 5 successive cycles or until the reservoir
is filled.
The CLEAN light (some models) will come on at
end of cycle and remain on until door is opened.
Child Lock Controls
To prevent children from accidently changing the
dishwasher cycle or starting the dishwasher, lock
the dishwasher controls by pressing and releasing
the RINSE ONLY pad (some models) or the NO
HEAT DRY pad (some models) for 3 seconds
while the door is latched. An indicator light on the
lock graphic pad will illuminate when the controls
are locked and no new selections can be made
until the lock is released. To unlock the controls,
press the RINSE ONLY pad or NO HEAT DRY
pad until the indicator light goes out.
(continued)
Status Window
The STATUS window, available on some models,
indicates the following activity:
Note: The time remaining could suddenly increase
or drop several minutes. This means the Smart
Sensor has checked the soil level and determined
if additional water fills are needed or if water fills
can be deleted.
1H-24H...........
CL..................
HO.................
MINUTES.........
PF..................
LO.........................Appears in window when the
7
Number of delay start hours.
The last hour will count down in
minutes.
Close dishwasher door. The
status indicator lights will also
flash to indicate current cycle
status.
Flashes to indicate a water heat
delay.
Number of minutes left in cycle
(1-99). If cycle is longer than 99
minutes, a small light will appear
in the lower right corner and
remain on until time counts
below 99.
Appears in window when
dishwasher is first installed, or
when power has been
interrupted. HI-TEMP WASH
and NO HEAT DRY indicator
lights will also flash. To clear,
touch START/CANCEL pad.
rinse aid dispenser is low and
needs to be refilled.

Advertisement

Table of Contents
loading

Table of Contents