EDGE2-MS DUAL MONITOR ARM PARTS AND TOOLS PLEASE REVIEW these instructions before beginning the assembly and adjustment procedures. Check that all the parts and tools listed below were provided with your order. Contact your supplier if any materials are your satisfaction. PARTS AND TOOLS PROVIDED Base Assembly (1) Monitor Arm (2)
Page 3
INSTALLATION OF BASE ASSEMBLY EDGE2-MS DUAL MONITOR ARM Two Base Assembly Attachment Methods • Clamp method. The base assembly is clamped to • Grommet method. The base assembly is secured a table or desk surface that is between 0.6" (15mm) through a grommet hole in the work surface, with thick and 3"...
EDGE2-MS DUAL MONITOR ARM INSTALLATION OF BASE ASSEMBLY Grommet Method This method can be used for work surfaces that have a grommet hole in an appropriate position. Surface thickness must be between 0.6" (15mm) and 1.5" (38.1mm), and the grommet hole diameter must be between 0.78" (20mm) 0.6"...
MONITOR ARM INSTALLATION EDGE2-MS DUAL MONITOR ARM Install Monitor Arms • Insert the monitor arms into the base assembly. Carefully align the protrusion on each monitor arm post with the indented groove on the base. Align • Secure each monitor arm by tightening the with Groove pre-installed set screws using the 2mm Allen key.
Page 6
EDGE2-MS DUAL MONITOR ARM MONITOR INSTALLATION Attach Monitors to VESA Mount Assemblies VESA • Remove the VESA plate from each VESA mount Plate assembly by pressing down on the plastic tab to release the lock. Pull the plate upward to remove. Attach VESA Plates to Monitors 3.9"...
FINAL ADJUSTMENTS EDGE2-MS DUAL MONITOR ARM Complete the Installation • Use the cable cover to help manage the monitor cables. Pinch the cover to remove it from the monitor arms, and again when re-installing it with the cables captured. • Make all necessary power and data connections. Tension Adjustments There are four possible swivel and tilt tension adjustments for each monitor arm: 1.