Table 10 Manipulating Pips Tiles - Videonics MXPro User Manual

PIPs
Manipulating the
Foreground Tile
This section explains how to change the position, size, shape, and so forth of the fore-
ground tile. In each case, do the steps after pressing PIPS , as described in the preceding
steps. You can do any of these steps while the PIP plays on the Output.
Table 10: Manipulating PIPs Tiles
To change tile...
Position
Size
( Resizing the tile normally distorts the image it contains.)
Shape
Mosaic
Use or press...
JOYSTICK
SHIFT+
SHIFT+
T-BAR
UP ARROW
DOWN ARROW
RIGHT ARROW
LEFT ARROW
SHIFT+0 (zero)
SHAPES
SHIFT+SHAPES
n
SHIFT+OK+T-BAR
Foreground Tile
Notes...
Moves tile around screen.
Snaps PIP tile to correct aspect ratio,
based on current horizontal
dimensions.
Snaps PIP tile to correct aspect ratio,
based on current vertical dimensions.
Dynamically resizes foreground tile and
its mask. Use the T-BAR to manually
zoom the image while maintaining
correct aspect ratio.
Increases the height of the foreground
tile and its mask.
Decreases the height of the foreground
tile and its mask.
Increase the width of the foreground tile
and its mask.
Decrease the width of the foreground
tile and its mask.
Restore PIP tile to default size, shape,
and position.
Cycles through available shapes for
foreground tile.
Cycles backward through shapes.
Applies a specific shape to the tile,
where n corresponds to the numbers
shown in the shapes following this
table.
Increases/decreases granularity of the
mosaic.
89