Setting Up A Transition; Running Transitions - Videonics MXPro User Manual

14
Chapter 2

Setting up a Transition

Selected Transition

Running Transitions

Automatic Transitions ¨ Press PLAY. MXPro runs the transition at a pre-determined speed.
PLAY
Speed
To set up a transition you need to select the sources you want to use and the transition
you want to use when switching between them. Here's how to transition from source A
to source B using a horizontal wipe.
¨ Press CUT/A to set A as the CURRENT source. MXPro shows a steadily glowing light
below the CUT button you press.
¨ Press NEXT/B to set B as the NEXT source (the one you want to see after the transi-
tion finishes running). The LED light above the button you press flashes to indicate
it is the NEXT source.
¨ Use the ARROW keys to highlight the Wipe transition in the Transitions Menu, as
shown in the following example.
Use LEFT and RIGHT ARROW s to move the selection horizontally. Use UP and
DOWN ARROW s to move the selection vertically: or, press 2 then OK to select the
transition by number.
The screen shows: The CURRENT source (A), the NEXT source (B), and the desired
effect (the horizontal wipe).
You can run transitions automatically or manually.
MXPro transitions between the two sources using the horizontal wipe transition.
Both the Preview and Output screens show the results.
At the end of the wipe, B is on the OUTPUT monitor — it has become the CURRENT
source. The yellow highlight above the preview images has changed to reflect that. Fur-
thermore, A is now the NEXT source and the green highlight has been changed to A.
¨ To wipe back and forth between sources A and B, press PLAY repeatedly.
¨ To change the speed at which a transition runs, press the SPEED button. The Speed
indicator under the transition icon changes.
¨ Press the button again until the desired speed appears. 0 is the slowest speed, 9 is
the fastest.
¨ Try this with various speeds: Change the speed and press PLAY.
Videonics MX-Pro User Guide