Quick Start Steps; Setting Up - Videonics MXPro User Manual

10
Chapter 2
Q S
UICK TART

Setting Up

Preview Monitor
Note
S
TEPS
Input
Source
IN 1
PREVIEW OUT
OUT Jacks
¨ Connect a COMPOSITE-type monitor to MXPro's PREVIEW OUT jack.
¨ Connect an Input Source (such as a VCR or camcorder) to MXPro's IN 1 jacks.
¨ Connect a second Input Source to MXPro's IN 2 jacks.
MXPro is set up, by default, to expect S-Video (Y/C) devices to be connected to the IN
1, IN 2, IN 3, and IN 4 input jacks. If you connect Composite devices to any of the
jacks, you must tell MXPro this fact. See "Using the Route Function" below after
completing the following steps.
¨ Connect a VCR's VIDEO IN and AUDIO IN jacks to the OUT jacks on the MXPro rear
panel. This is the device where you record the program.
¨ Connect a television or monitor to the recording VCR according to their instruc-
tions. Having this monitor available lets you see exactly what is being recorded (or,
output).
These instructions assume a two-monitor setup. If you are using only one monitor, con-
nect it to PREVIEW OUT.
¨ Connect the MXPro power supply to the power supply jack on the rear panel.
¨ Connect the MXPro's power cord to a suitable outlet.
¨ Turn on all devices (the MXPro power switch is located on the right end of the unit)
and let the tapes roll.
00:00
IN 2
Videonics MX-Pro User Guide
Input
Source
Output Monitor
VIDEO IN
AUDIO IN
Output Device
00:00
00:00