Advertisement
Quick Links
INSTALLATION, OPERATION, AND SERVICE MANUAL FOR
Model
Warmers
KB1-1F
1
KB2-2F
2
KB3-3F
3
*
KBAP/LD
N/A
* We recommend up to 3 gallon bottles only due to stability, unless anchored to wall.
WARNING - Read and follow installation instructions before plugging or wiring in machine to electrical circuit. Warranty will
be void if unit is connected to any voltage other than that specified on the name plate.
FILL BREWER TANK WITH WATER BEFORE CONNECTING TO POWER SUPPLY !
1)
Place bottle on top of brewer with neck of bottle extending into receiving hole.
2)
Hold faucet open until water flows from it. Allow one minute for automatic leveling of water in tank. Plug or
wire brewer to appropriate voltage circuit as indicated on serial tag. Place decanter under brew basket and turn lower
warmer switch to the ON position. Depress brew start switch & check volume of water delivered into decanter.
Adjust timer to deliver desired amount of water. Turn timer dial clockwise to increase volume of water, and counter
clockwise to decrease volume.
3)
Allow 10 to 15 minutes for water in tank to heat to brewing temperature. Water has reached brewing temperature
when thermostat clicks off and heating noise stops. Green ready light will be lit on models so equipped. Empty
decanter and replace.
4)
Run one cycle to check for the proper temperature setting with an accurate thermometer. Take the temperature of
this water at a point below the brew basket opening, at the start of the brew cycle and when the decanter is half full.
Recommended temperature of the water is approximately 195 F.
5)
In higher altitude locations (5000 feet above sea level) the thermostat may have to be adjusted lower to prevent
boiling.
6)
CAUTION: On faucet models the water faucet will dispense hot water when the handle is depressed. The faucet may
be operated during brew cycle.
N E W C O E N T E R P R I S E S
KB SERIES BOTTLED WATER BREWERS
Width
Length
9-1/2"
18"
18"
9-1/2"
16-1/2"
18"
9-1/2
18"
INSTALLATION INSTRUCTIONS
Height
Weight
20-1/8"
34
22-3/8"
39
20-1/8"
43
26 1/2"
42
Man P.N. 781224
Watts
Amps
1500
12.5
1600
13.3
1700
14.2
1400
11.7
Rev. 3-00
Advertisement
Related Manuals for Newco KB Series
Summary of Contents for Newco KB Series
- Page 1 Man P.N. 781224 Rev. 3-00 N E W C O E N T E R P R I S E S INSTALLATION, OPERATION, AND SERVICE MANUAL FOR KB SERIES BOTTLED WATER BREWERS Model Warmers Width Length Height Weight Watts Amps KB1-1F 9-1/2"...
- Page 2 Prompt disposition will be made if item proves to be defective, within warranty. Before returning any item, write or call Newco, or the dealer from whom the product was purchased, giving model number, serial number, and date of purchase, and describe nature of the defect.
- Page 3 SYMPTOM POSSIBLE CAUSE WHAT TO CHECK REMEDY CAN'T START BREW 1. No Water. 1. Water bottle is empty. 1. Replace empty bottle with new one. CYCLE 2. No power. 2. Fuse or circuit breaker. 2. Replace or reset circuit protector as req'd. Power cord and plug connections.
- Page 4 3. Timer 3. Solid state timers are not 3. Replace timer. repairable. If timer will not shut off, replace timer. WIRING DIAGRAM Newco Enterprises, Inc. * 1735 S. River Rd. * P.O. Box 852 * St. Charles, MO 63302...