Table of Contents
Advertisement
To Transfer Audio to the In-Vehicle
Bluetooth System
The cellular phone must be paired and connected with
the Bluetooth system before a call can be transferred.
The connection process can take up to two minutes after
the key is turned to the ON/RUN or ACC/ACCESSORY
position.
During a call with the audio on the cell phone,
b g
press
for more than two seconds. The audio
switches from the cell phone to the vehicle.
Voice Pass-Thru
Voice Pass-Thru allows access to the voice recognition
commands on the cell phone. See the cell phone
manufacturers user guide to see if the cell phone
supports this feature. This feature can be used to
verbally access contacts stored in the cell phone.
b g
1. Press and hold
responds with "Ready" followed by a tone.
2. Say "Bluetooth". The system responds with
"Bluetooth ready" followed by a tone.
3. Say "Voice". The system responds with "OK,
accessing <phone name>".
•
The cell phone's normal prompt messages will
go through its cycle according to the phone's
operating instructions.
4-82
for two seconds. The system
Dual Tone Multi-Frequency (DTMF)
Tones
The in-vehicle Bluetooth system can send numbers and
numbers stored as name tags during a call. This is
used when calling a menu driven phone system.
Account numbers can be programmed into the
phonebook for retrieval during menu driven calls.
Sending a Number During a Call
b g
1. Press
. The system responds with "Ready"
followed by a tone.
2. Say "Dial". The system responds with "Say a
number to send tones" followed by a tone.
3. Say the number to send.
•
If the system clearly recognizes the number it
responds with "OK, Sending Number" and the
dial tones are sent and the call continues.
•
If the system is not sure it recognized the
number properly, it responds "Dial Number,
Please say yes or no?" followed by a tone. If the
number is correct, say "Yes". The system
responds with "OK, Sending Number" and the
dial tones are sent and the call continues.
Advertisement
Chapters
Table of Contents
