Playing The Radio; Finding A Station - Chevrolet Malibu 2010 Owner's Manual

In rare cases, a radio station could broadcast incorrect
information that causes the radio features to work
improperly. If this happens, contact the radio station.

Playing the Radio

O (Power/Volume): Press to turn the system on and
off. Turn to increase or decrease the volume.
Speed Compensated Volume (SCV): Radios with the
Speed Compensated Volume (SCV) feature
automatically adjust the radio volume to compensate for
road and wind noise as the vehicle speeds up or
slows down, so that the volume level is consistent.
To activate SCV:
1. Set the radio volume to the desired level.
2. Press MENU to display the radio setup menu.
3. Press the softkey under the AUTO VOLUM tab on
the radio display.
4. Press the softkey under the desired Speed
Compensated Volume setting (OFF, Low, Med, or
High) to select the level of radio volume
compensation. The display times out after
approximately 10 seconds. Each higher setting
allows for more radio volume compensation at faster
vehicle speeds.
4-56

Finding a Station

BAND: Press to choose between FM1, FM2, AM, or
XM™ (if equipped) on the Radio with CD (Base). Press
to choose between FM, AM, XM (if equipped) on the
Radio with CD (MP3) and USB Port, or the Radio with
CD (MP3).
f
(Tune): Turn to select radio stations.
©
SEEK: Press to seek or scan stations with a strong
signal in the selected band.
•
To seek stations, press and release
to the previous station and stay there.
•
To scan stations, press and hold
few seconds until the radio beeps once. The
radio goes to a station, plays for a few seconds,
then goes to the next station. Press
to stop scanning.
•
To scan preset stations in the selected band, press
©
and hold SEEK for four seconds until a double
beep sounds. The radio goes to a stored preset,
plays for a few seconds, then goes to the next
stored preset. Press
scanning preset stations.
©
SEEK to go
©
SEEK for a
©
SEEK again
©
SEEK again to stop