Chevrolet Malibu 2010 Owner's Manual page 115

Hide thumbs Also See for Malibu 2010:
Table of Contents

Advertisement

There are other conditions which can affect the
performance of the transmitter, see Remote Keyless
Entry (RKE) System on page 3-4 for additional
information.
/
(Remote Start): This button will be on the RKE
transmitter if you have remote start.
To start the vehicle using the remote start feature:
1. Aim the transmitter at the vehicle.
2. Press and release the transmitter's lock button,
then immediately press and hold the transmitter's
remote start button for about four seconds or
until the vehicle's turn signal lamps flash. The doors
will lock.
When the vehicle starts, the parking lamps turn on
and remain on while the engine is running.
The remote start feature provides two separate starts
per ignition cycle, each with 10 minutes of engine
running time, or one start with a time extension. The
first start must expire or be canceled to get two separate
10 minute starts.
If it is the first remote start since the vehicle has been
driven, repeat the previous steps, while the engine
is still running, to extend the engine running time by
10 minutes from the time you repeat the steps for
remote starting. The remote start running time can be
extended one time and only after the first remote start.
After entering the vehicle during a remote start,
insert and turn the key to ON/RUN to drive the vehicle.
The engine will shut off automatically after 10 minutes,
unless a time extension has been done or the vehicle's
key is inserted into the ignition switch and turned to
ON/RUN.
To manually shut off a remote start, do any of the
following.
Aim the RKE transmitter at the vehicle and press
and release the remote start button.
Turn on the hazard warning flashers.
Turn the ignition switch out of LOCK/OFF position
and then back to LOCK/OFF.
3-7

Advertisement

Table of Contents
loading

Table of Contents