Programming Transmitters To The Vehicle - Chevrolet Malibu 2010 Owner's Manual

Q
(Lock): Press to lock all the doors. The interior
lamps turn off after all of the doors are closed. If enabled
through the Driver Information Center (DIC), the
remote lock feedback can be programmed to have the
horn chirp and/or the turn signals flash to confirm
locking. See "LOCK HORN" and "LIGHT FLASH" under
DIC Vehicle Personalization on page 4-47 for more
information.
Q
Pressing may also arm the content theft-deterrent
system. See Content Theft-Deterrent on page 3-18.
K
(Unlock): Press once to unlock the driver door.
K
Press again within five seconds to unlock all remaining
doors. The interior lamps turn on and stay on for
20 seconds or until the ignition is turned on. If enabled
through the DIC, the remote unlock feedback can be
programmed to have the horn chirp and/or the turn
signals flash to confirm unlocking. See "UNLOCK HORN"
and "LIGHT FLASH" under DIC Vehicle Personalization
on page 4-47 for more information.
The high-beam headlamps, parking lamps, and back-up
lamps may come on each time
(Exterior) LIGHTS" under DIC Vehicle Personalization on
page 4-47 for additional information.
K
Pressing on the RKE transmitter disarms the content
theft-deterrent system. See Content Theft-Deterrent on
page 3-18.
K
is pressed. See "EXT
V
(Remote Trunk Release): Press and hold for
about one second to unlock the trunk. The trunk can be
opened with the transmitter when the vehicle speed
is less than 3 km/h (2 mph) or when the ignition is off.
L
(Vehicle Locator/Panic Alarm): Press and release
to locate the vehicle. The horn sounds three times
and the headlamps and turn signals flash three times.
L
Press and hold for about three seconds to initiate the
panic alarm. The horn sounds and the headlamps
and turn signals flash for 30 seconds. Press
to cancel the panic alarm.
Programming Transmitters to the
Vehicle
Only RKE transmitters programmed to the vehicle
will work. If a transmitter is lost or stolen, a replacement
can be purchased and programmed through your
dealer/retailer. When the replacement transmitter is
programmed to the vehicle, all remaining transmitters
must also be programmed. Any lost or stolen
transmitters no longer work once the new transmitter is
programmed. Each vehicle can have up to four
transmitters programmed to it.
L
again
3-5