SECO-LARM ENFORCER CS-PD535-TAQ Manual

Infrared Proximity Sensor
Manual
CS-PD535-TAQ shown
Model
CS-PD535-TAQ
CS-PD535-TBQ
Installation:
1. The sensor is meant to be installed on a rigid thin surface,
maximum thickness
2. Use the mounting template to mark and cut holes in the
mounting surface. Disassemble the sensor for installation.
3. Install the sensor as illustrated below except for the back cover.
4. Punch through the wiring grommet to thread the wires through
and connect them to the terminal block.
5. To reverse the LED colors for standby and activated, remove
the jumper pin (see Fig. 1).
6. To adjust the sensor's range, turn the trimpot counterclockwise
(decrease) or clockwise (increase) (see Fig. 1).
7. To adjust the output time, turn the trimpot counterclockwise
(decrease) or clockwise (increase). To set to toggle, turn the
trimpot all the way counterclockwise (see Fig. 1).
8. Install the back cover.
Overview:
LED
Indicator
Sensor
LED Colors
Green/Red
Green/Blue
/ " (2mm).
1
16
Alignment Alignment
pin slot
Mounting surface
max. 1/16" (2mm)
Features:
 No-touch operation reduces the risk of
spread of germs, viruses, etc., through
cross-contamination
 Adjustable sensor range 2
3A relay, adjustable trigger duration 0.5~30
seconds or toggle
 LED illuminated sensor area for easy
identification
 Selectable LED colors (CS-PD535-TAQ
turns from red to green or green to red,
CS-PD535-TBQ turns from blue to green or
green to blue) when the sensor is activated
Faceplate Motherboard
mounting screws x4 mounting screws x2
Terminal block
/ "-8" (6~20 cm),
3
8
Fig. 1
LED Color jumper
Output time
trimpot
Sensor range
trimpot
– +
COM NO NC
Power Relay
input
output
Rear cover
mounting screws x4
Wiring grommet