Bunn IC2 Installation And Operating Instructions Manual

Bunn ic2, ic2b iced coffee brewers installation & operating instructions

Advertisement

Quick Links

INSTALLATION & OPERATING INSTRUCTIONS
INTRODUCTION
This equipment will brew a batch of fresh coffee into an awaiting vessel and dispense at approximately
room temperature to conserve ice. The brewer is only for indoor use on a sturdy counter or shelf and requires a
minimum of 32 inches of clearance above the counter.
WARRANTY
Bunn-O-Matic Corp. ("Bunn") warrants the equipment manufactured by it to be commercially free from
defects in material and workmanship existing at the time of manufacture and appearing within one year from the
date of installation. This warranty does not apply to any equipment, component or part that was not manufac-
tured by Bunn or that, in Bunn's judgement, has been affected by misuse, neglect, alteration, improper installa-
tion or operation, improper maintenance or repair, damage or casualty.
DISCONTINUED VERSION
THE FOREGOING WARRANTY IS EXCLUSIVE AND IS IN LIEU OF ANY OTHER WARRANTY, WRITTEN OR
ORAL, EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTY OF EITHER
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. The agents, dealers or employees of Bunn
The information in this manual
are not authorized to make modifications to this warranty or to make additional warranties that are binding on
Bunn. Accordingly, statements by such individuals, whether oral or written, do not constitute warranties and
should not be relied upon.
The Buyer shall give Bunn prompt notice of any claim to be made under this warranty by telephone at (217)
529-6601 or by writing to Post Office Box 3227, Springfield, Illinois, 62708-3227. If requested by Bunn, the
Buyer shall ship the defective equipment prepaid to an authorized Bunn service location. If Bunn determines, in
its sole discretion, that the equipment does not conform to the warranty, Bunn shall repair the equipment with no
charge for parts during the one year warranty period and no charge for labor by a Bunn Authorized Service
Representative during the one year warranty period. If Bunn determines that repair is not feasible, Bunn shall, at
its sole option, replace the equipment or refund the purchase price for the equipment.
THE BUYER'S REMEDY AGAINST BUNN FOR THE BREACH OF ANY OBLIGATION ARISING OUT OF THE
SALE OF THIS EQUIPMENT, WHETHER DERIVED FROM WARRANTY OR OTHERWISE, SHALL BE LIMITED, AS
SPECIFIED HEREIN, TO REPAIR OR, AT BUNN'S SOLE OPTION, REPLACEMENT OR REFUND. Bunn shall not
be liable for any other damage or loss, including, but not limited to, lost profits, lost sales, loss of use of equip-
ment, claims of Buyer's customers, cost of capital, cost of down time, cost of substitute equipment, facilities or
services, or any other special, incidental or consequential damages.
PHONE: (217) 529-6601 FAX: (217) 529-6644
10822.0000A 6/94 © 1994 BUNN-O-MATIC CORPORATION
is no longer current.
BUNN-O-MATIC CORPORATION
POST OFFICE BOX 3227
SPRINGFIELD, ILLINOIS 62708-3227
IC2 & IC2B
ICED COFFEE BREWERS

Advertisement

Table of Contents
loading

Summary of Contents for Bunn IC2

  • Page 1 The Buyer shall give Bunn prompt notice of any claim to be made under this warranty by telephone at (217) 529-6601 or by writing to Post Office Box 3227, Springfield, Illinois, 62708-3227. If requested by Bunn, the Buyer shall ship the defective equipment prepaid to an authorized Bunn service location.
  • Page 2: User Notices

    USER NOTICES The notices on this brewer should be kept in good condition. Replace unreadable or damaged labels. 03408.0000 ELECTRICAL REQUIREMENTS CAUTION - Do not connect the brewer to the power source until specified in Initial Set-Up. WHITE NEUTRAL 120V.A.C. L1 BLACK These brewers require 2-wire, grounded service rated 120 or 200 volts ac or 3-wire, grounded service rated 120/208 or 120/240 volts ac, 20 amp, single phase, 60 Hz.
  • Page 3: Plumbing Requirements

    " water supply line. A tight coil of copper tubing in the water line will facilitate moving the brewer to clean the countertop. Bunn-O-Matic does not recommend the use of a saddle valve to install the brewer. The size and shape of the hole made in the supply line by this type of device may restrict water flow.
  • Page 4 INITIAL SET-UP (cont.) Connect the brewer to the power source. Place the On/Off switch in the lighted “ON” position, the batch selector in the “FULL” position, and momentarily press the start switch. Water will flow into the tank for approximately eight minutes. Press the start switch again to initiate a second cycle.
  • Page 5: Operating Controls

    Begin each brew cycle with a clean empty brew funnel and dispenser. (Be sure the dispenser lid doesn’t interfere with the flow of dilution water.) Insert a BUNN ® tea filter into the funnel. Pour the recommended amount of fresh coffee into the filter.
  • Page 6: Replacement Parts

    REPLACEMENT PARTS 03772.0000 ... Base Guide 00603.0000 ... Cable Clamp .437” 03024.0005 ... Control Thermostat 03409.0000 ... Decal, Caution, Hot Liquid 03408.0000 ... Decal, Caution, Remove Funnel Slowly 24739.0000 ... Decal, Hood Front 03717.0000 ... Dilution Nozzle 03773.0000 ... Dilution Nozzle Spacer Housing 00459.0001 ...
  • Page 7: Single Phase

    SCHEMATIC WIRING DIAGRAM IC2 READY INDICATOR SW. & THERMOSTAT THERMOSTAT ON/OFF SW WHI/RED WHI/RED WHI/RED START SW BREW WHI/ORA TIMER 3 WHI/GRN WHI/YEL SCHEMATIC WIRING DIAGRAM IC2B READY INDICATOR SW. & THERMOSTAT ON/OFF SW WHI/RED WHI/RED WHI/RED BREW WHI/ORA TIMER 3...

This manual is also suitable for:

Ic2bHc-1Hc-3Hc-2

Table of Contents