Draytek Vigor 2700 User Manual page 101

My WAN IP
Remote Gateway IP
Remote Network IP/
Remote Network Mask
More
RIP Direction
RIP Version
For NAT operation, treat
remote sub-net as
Change default route to
this VPN tunnel
Vigor2700 Series User's Guide
the dial-in user. The budget will be decreased automatically per
callback connection. The default value 0 means no limitation of
callback period.
This field is only applicable when you select PPTP or L2TP
with or without IPSec policy above. The default value is 0.0.0.0,
which means the Vigor router will get a PPP IP address from
the remote router during the IPCP negotiation phase. If the PPP
IP address is fixed by remote side, specify the fixed IP address
here.
This field is only applicable when you select PPTP or L2TP
with or without IPSec policy above. The default value is 0.0.0.0,
which means the Vigor router will get a remote Gateway PPP
IP address from the remote router during the IPCP negotiation
phase. If the PPP IP address is fixed by remote side, specify the
fixed IP address here.
Add a static router to direct all traffic destined to this Remote
Network IP Address/ Remote Network Mask through the
VPN connection. For IPSec, this is the destination clients IDs
of phase 2 quick mode.
Add a static router to direct all traffic destined to more Remote
Network IP Addresses/ Remote Network Mask through the
VPN connection. This is usually used when you find there are
several subnets behind the remote VPN router.
The option specifies the direction of RIP (Routing Information
Protocol) packets. You can enable/disable one of direction here.
Herein, we provide four options: TX/RX Both, TX Only, RX
Only, and Disable.
Select the RIP protocol version. Specify Ver. 2 for greatest
compatibility.
While communicating with remote subnet, the router can treat
it as private subnet by sending packets with the router's
private IP address, or treat it as public subnet by sending
packets with the router's public IP address.
Check this box to change the default route with this VPN
tunnel. Be aware that this setting is available only for one
WAN interface is enabled. It is not available when both WAN
95