Mini Tower, Desktop, And Small Form Factor Computers - Back-Panel Connectors - Dell OptiPlex GX620 Quick Reference Manual

voltage selection switch
4
(may not be available on
certain computers)
5 padlock ring
6 cover release latch
Mini Tower, Desktop, and Small Form Factor Computers — Back-Panel Connectors
parallel connector
1
link integrity light
2
16
Quick Reference Guide
Your computer is equipped with either an auto-sensing voltage selector or a
manual voltage-selection switch. Computers with an auto-sensing voltage selector
do not have a voltage selection switch on the back panel and can automatically
detect the correct operating voltage.
To help avoid damaging a computer with a manual voltage-selection switch, set
the switch for the voltage that most closely matches the AC power available in
your location.
NOTICE:
In Japan, the voltage selection switch must be set to the 115-V
position even though the AC power available in Japan is 100 V.
Also, ensure that your monitor and attached devices are electrically rated to
operate with the AC power available in your location.
Insert a padlock to lock the computer cover.
Use this latch to open the computer cover.
1
10 9
Connect a parallel device, such as a printer, to the parallel connector. If you have a
USB printer, plug it into a USB connector.
NOTE:
The integrated parallel connector is automatically disabled if the computer
detects an installed card containing a parallel connector configured to the same
address. For more information, see "System Setup Options" in your online User's
Guide.
• Green — A good connection exists between a 10-Mbps network and the
computer.
• Orange — A good connection exists between a 100-Mbps network and the
computer.
• Yellow — A good connection exists between a 1-Gbps (or 1000-Mbps) network
and the computer.
• Off — The computer is not detecting a physical connection to the network.
2 3 4
8
5
6
7