Definitive Technology Mythos Six User Manual

Definitive Technology
For more information on Definitive Technology Loudspeakers and accessories,
visit www.definitivetech.com, or email info@definitivetech.com.
Definitive Technology, Owings Mills, Maryland, USA. 410-363-7148
MYTHOS SIXSTAND
The only stand custom designed and engineered for Definitive Technology Mythos Six Loudspeakers.
Parts:
• Post , including Top Cap, Pads, Speaker Screw
• Translucent Bottom Pad
• Glass Base , including preattached Feet.
• Carpet Spikes, Rubber Feet
• Bottom Assembly: Bolt Cover Skirt
• Hex Key.
Attach Post to Glass Base:
1. With Glass Base upside down (feet up), place the Bolt Cover Skirt
(with curve matching base) over Screw Holes.
2. Place the Steel Insert
into this assembly.
3. Slide the Translucent Bottom Pad
This will hold the assembly in place.
4. Line up Hex Key with bottom of Post
5. Secure assembly to Post by tightening the two Cap Screws firmly using the Hex Key.
Do not overtighten.
6. Attach Carpet Spikes (for use with carpet) or Rubber Feet (for hard floor use).
7. Set stand upright. Push Spikes (if used) into carpet for stability.
Attach Mythos Six Speaker to Stand:
1. Prewire the Mythos Six Stand Post using the hidden wire channel provided.
2. Make your wire connections to the Mythos Six Loudspeaker before attaching the
loudspeaker to the stand.
3. Remove the plastic plug from the Insert Nut on the rear of the Mythos Six
Loudspeaker. This is the small hole located above the connectors.
4. Position the Mythos Six Loudspeaker to accept the Mythos Six Stand's Speaker Screw.
Insert a Hex Key through the Mythos Six Stand's Post and tighten the Speaker Screws
into the Insert Nut, alternating between tightening each screw (if one screw is tightened
first, it will be difficult to tighten the other). Tighten securely, but do not overtighten.
Mythos Six Loudspeaker front stage speaker setup: For best imaging performance,
create an equilateral triangle between the speakers and your listening position.
Aim speakers "in," if necessary.
USER'S GUIDE
, Hidden Wire Channel
.
.
, Steel Insert
into the Bolt Cover Skirt. Insert the Two Cap Screws
over Screws on the other side of the Glass Base.
.
.
, Cap Screws (2) .
open side up