S-Video Connections; Component Connections - CyberHome CH-DVD 300 Operation Manual

S-Video
This is a higher quality connection than standard composite video, and requires a special S-Video cable not included. The S-Video
connector is distinguishable by its 4 pins, as shown below. If your TV has an S-Video input, it's recommended that you use this type
of connection for better picture quality.
1
First, obtain a special S-Video cable. Connect the S-
Video output from the unit to the corresponding input
on your TV.
2
Turn on the DVD Player.
3
On your TV, select the S-Video input. This is normally
done by selecting "Video 2" or "AV2" with the remote
control. On some TVs, this is done by selecting a
particular channel.
TV with
S-Video Input
Component Video
The highest quality video connection, component video requires separate cables for the Y, Pb/Cb, Pr/Cr signals. To use the
progressive scan option on this unit, you'll need to use the component video output. Using the component video output requires these
1
First, use the supplied A/V cable to connect to the
composite video input on your TV.
2
Enter the player's Setup Menu by pressing SETUP on the
remote control.
3
Change the VIDEO OUTPUT setting to YCbCr. If you are
using a Progressive Scan TV, change the SCAN MODE to
PROGRESSIVE.
4
Exit SETUP and connect the Component Video cables.
Select the correct video input on your TV.
Y Pb/Cb Pr/Cr
Component Video
Input Jacks
CONNECTIONS
AUDIO OUT
COAXIAL
S-VIDEO
VIDEO
INPUT
Component
Video Cable
4
You should now see the DVD players' splash screen on
the TV.
S-Video
Input Jack
VIDEO
R
Pb/Cb Pr/Cr
Y
S-VIDEO
L
PROGRESSIVE SCAN
COMPONENT VIDEO OUT
COMPONENT VIDEO
S
VIDEO
INPUT
POWER DISPLAY SETUP
MENU GOTO
TITLE
PBC
SUBTITLE
ANGLE AUDIO
Reset the video output
!
If the SCAN MODE setting is set to PROGRESSIVE but you are
not using a progressive scan-capable TV, you will lose video . If
this happens, reset the video to the default Interlaced mode,
which is used by most TVs.
To reset the SCAN MODE, open the disc tray and press the
STOP button on the front panel for five seconds.
11
S-Video Cable
TV with
Component
Video Input /
Progressive Scan
capability.
2
OPEN/CLOSE
PROGRAM
TV OUTPUT
VIDEO OUTPUT
MUTE
SCAN MODE
BRIGHTNESS
CONTRAST
SATURATION
3
NTSC
YCbCr
PROGRESSIVE