SECO-LARM ENFORCER SK-919TP2D-P Operation Manual

ENFORCER Desktop RF Wireless Transmitter Manual
Replacing the Rechargeable Battery
Battery life depends on the amount of usage. When the storage capacity of the rechargeable battery becomes
noticeably smaller, and the operating time between each charge becomes shorter, the rechargeable battery
most likely needs replacement.
Should the rechargeable battery require replacement, slide the "Battery Power" switch to the OFF position.
Remove the 4 screws on the left-side panel (where the charging jack is located).
Carefully remove the 9-volt rechargeable battery and unplug the battery connector. Next, replace the old
battery with a new rechargeable battery and attach the battery connector.
NOTE: Make sure to charge the new battery overnight before the first use.
General Specifications
Operating Frequency: 315MHz
Operating Voltage: 9VDC (rechargeable Nickel Metal Hydride battery included)
Operating Current: 100uA @ 9VDC (standby)
10mA @ 9VDC (activated)
17mA max. charge current for ST-1212-U0.5A
No. of Buttons: SK-919TP4D-P: 4 Buttons
SK-919TP2D-P: 2 Buttons
SK-919TP2D-F: 2 Buttons
No. of Channels: SK-919TP4D-P: Fixed Code, 15-channel (max.)
SK-919TP2D-P: Fixed Code, 3-channel (max.)
SK-919TP2D-F: Fixed Code, 3-channel (max.)
1 3 1
Dimensions: 6 / " x 4 / " x 2 / " (159 x 121 x 58 mm)
4 4 4
WARRANTY:
This SECO-LARM product is warranted against defects in material and workmanship while used in
normal service for a period of one (1) year from the date of sale to the original consumer customer. SECO-LARM's
obligation is limited to the repair or replacement of any defective part if the unit is returned, transportation prepaid, to
SECO-LARM. This Warranty is void if damage is caused by or attributed to acts of God, physical or electrical misuse or
abuse, neglect, repair, or alteration, improper or abnormal usage, or faulty installation, or if for any other reason
SECO-LARM determines that such equipment is not operating properly as a result of causes other than defects in
material and workmanship. The sole obligation of SECO-LARM, and the purchaser's exclusive remedy, shall be limited
to replacement or repair only, at SECO-LARM's option. In no event shall SECO-LARM be liable for any special,
collateral, incidental, or consequential personal or property damages of any kind to the purchaser or anyone else.
NOTICE:
The information and specifications printed in this manual are current at the time of publication.
However, the SECO-LARM policy is one of continual development and improvement. For this reason, SECO-LARM
reserves the right to change specifications without notice. SECO-LARM is also not responsible for misprints or
typographical errors.
Copyright © 2007 SECO-LARM U.S.A., Inc. All rights reserved. This material may not be reproduced or copied, in
whole or in part, without the written permission of SECO-LARM.
®
SECO-LARM U.S.A., Inc.
16842 Millikan Avenue, Irvine, CA 92606
Tel: 800-662-0800 / 949-261-2999 Fax: 949-261-7326
file: D/DTP/Desktop_manual_074b.pmd
Order Part #7xxxxxxxx
Website: www.seco-larm.com
E-mail: sales@seco-larm.com
PITSW1
ENFORCER Desktop RF Wireless Transmitter Manual
Operation Manual
Desktop and Footswitch
RF Wireless Transmitters
SK-919TP2D-P
SK-919TP2D-F
Three Models
SK-919TP2D-P - - Two-button desktop transmitter
SK-919TP4D-P - - Four-button desktop transmitter
SK-919TP2D-F - - Two-button footswitch transmitter
®
SK-919TP4D-P
SECO-LARM
®