Download Print this page
Casio G2310R-1 Operation Manual

Casio G2310R-1 Operation Manual

Casio g2310r-1: user guide

Advertisement

MO0907-EA
Getting Acquainted
Congratulations upon your selection of this CASIO watch. To get the most out of your
purchase, be sure to read this manual carefully.
Keep the watch exposed to bright light
Bright Light
Solar cell
• The watch continues to operate, even when it is not exposed to light. Leaving the
watch in the dark can cause the battery to run down, which will result in some watch
functions to be disabled. If the battery goes dead, you will have to re-configure watch
settings after recharging. To ensure normal watch operation, be sure to keep it
exposed to light as much as possible.
Battery charges in the light.
Bright Light
Solar cell
(Converts light to
electrical power.)
LEVEL 1
LEVEL 2
LEVEL 3
Charge
LEVEL 4
Rechargeable battery
General Guide
• Press C to change from mode to mode.
• In any mode, press L to illuminate the display.

Timekeeping

Current Time
Day of week
Month – Day
PM
Hour : Minutes
L
indicator
Seconds
B
B
Dual Time
Read This Before You Set the Time and Date!
This watch is preset with a number of city codes, each of which represents the time
zone where that city is located. When setting the time, it is important that you first
select the correct city code for your Home City (the city where you normally use the
watch). If your location is not included in the preset city codes, select the preset city
code that is in the same time zone as your location.
• Note that all of the times for the World Time Mode city codes are displayed in
accordance with the time and date settings you configure in the Timekeeping Mode.
To set the time and date
• For full information on city codes, see the "UTC Differential/City Code List".
3. Press C to move the flashing in the sequence shown below to select the other
setting.
City Code
DST
Power Saving
Operation Guide 3192
The electricity generated by the solar cell of the watch is
stored by a rechargeable battery. Leaving or using the
watch where it is not exposed to light causes the battery to
run down. Make sure the watch is exposed to light as
much as possible.
• When you are not wearing the watch on your wrist,
position the face so it is pointed at a source of bright
light.
• You should try to keep the watch outside of your sleeve
as much as possible. Charging is reduced significantly if
the face is covered only partially.
Battery discharges in the dark.
Electrical
energy
All
LEVEL 1
functions
LEVEL 2
enabled
LEVEL 3
Dis-
charge
LEVEL 4
Timekeeping Mode
Press C.
Press the B button to toggle between the day of the
week and date, and the currently selected World Time city
and time (Dual Time).
Use the Timekeeping Mode to set and view the current
time and date.
City code
Dual time
1. In the Timekeeping Mode hold down A until the city
code starts to flash, which indicates the setting screen.
2. Use D and B to select the city code you want.
• Make sure you select your Home City code before
changing any other setting.
12/24-Hour
Seconds
Hour
Format
Illumination
Operation
Day
Month
Duration
Tone
• The actual level at which some functions are disabled depends on the watch model.
• Frequent display illumination can run down the battery quickly and require charging.
The following guidelines give an idea of the charging time required to generate
enough power for normal daily operations.
Approximately 5 minutes exposure to bright sunlight coming in through a window
Approximately 8 hours exposure to indoor fluorescent lighting
• Be sure to read "Power Supply" for important information you need to know
when exposing the watch to bright light.
If the display of the watch is blank...
If the display of the watch is blank, it means that the watch's Power Saving function
has turned off the display to conserve power.
• See "Power Saving Function" for more information.
Note that CASIO COMPUTER CO., LTD. assumes no responsibility for any damage
or loss suffered by you or any third party arising through the use of this product or
its malfunction.
About This Manual
• Depending on the model of your watch, display text appears either as dark figures
on a light background or light figures on a dark background. All sample displays in
this manual are shown using dark figures on a light background.
• Button operations are indicated using the letters shown in the illustration.
• Each section of this manual provides you with the information you need to perform
operations in each mode. Further details and technical information can be found in
the "Reference" section.
Some or all
functions
disabled
World Time Mode
Countdown Timer Mode
4. When the timekeeping setting you want to change is flashing, use D or B to
change it as described below.
Screen:
To do this:
Specify your Home City
Cycle between Daylight Saving
Time (
(
Toggle between 12-hour (
and 24-hour (
Reset the seconds to zero (
Change the hour and minutes
Change the year, month and day
Toggle between Button Operation
Tone on(
Toggle the display illumination
duration between 1.5 seconds
(
Toggle between Power Saving on
(
5. Press A to exit the setting screen.
To specify your Home City
City code
PM
indicator
Hour : Minutes
Minutes
Year
Alarm Mode
Stopwatch Mode
Do this:
Use D (east) and B (west).
Press D.
) and Standard Time
).
Press D.
)
) timekeeping
Press D.
)
Use D (+) and B (–).
Press D.
) and off (
)
Press D.
) and three seconds (
)
Press D.
) and off (
)
1. In the Timekeeping Mode, hold down A { til the city
code starts to flash, which indicates the setting screen.
2. Press D (east) and B (west) to select the city code
you want to use as your Home City.
• For full information on city codes, see the "UTC
Differential/City Code List".
3. Press A to exit the setting screen.
Seconds
1

Advertisement

loading

Summary of Contents for Casio G2310R-1

  • Page 1: Timekeeping

    MO0907-EA Getting Acquainted Congratulations upon your selection of this CASIO watch. To get the most out of your purchase, be sure to read this manual carefully. Keep the watch exposed to bright light The electricity generated by the solar cell of the watch is Bright Light stored by a rechargeable battery.
  • Page 2: World Time

    The alarm tone sounds at the preset time for 10 seconds, regardless of the mode the watch is in. In the case of the snooze alarm, the alarm operation is performed a total of seven times, every five minutes, until you turn the alarm off.
  • Page 3: Illumination

    Also take care that sudden illumination by the auto light switch does not startle or distract others around you. • • • • • When you are wearing the watch, make sure that its auto light switch is turned off before riding a bicycle or operating a motorcycle or any other motor vehicle.
  • Page 4: Reference

    • Wearing the watch inside the sleeve of clothing can cause it to enter the sleep state. • The watch will not enter the sleep state between 6:00 AM and 9:59 PM. If the watch is already in the sleep state when 6:00 AM arrives, however, it will remain in the sleep state.

This manual is also suitable for:

3192