Page 1
INTRODUCTION This quick guide will assist you with the use of the scala- 700 headset. For more detailed information please download the User Manual from our website at www.cardowireless.com. Before using the scala-700 we recommend that you familiarize yourself with the ®...
BEFORE USING 1. Make sure that the headset is fully charged for at least four hours before initial use. 2. To charge the headset, plug the charger into the headset’s Charging Jack, which is located just below the Wheel. 3. While charging, the red Status Light illuminates. When charging is completed the light will turn off.
Page 3
TURNING THE HEADSET ON FOR THE FIRST TIME In order for your headset to work with your cellular phone, they must first recognize each other. This process is called “pairing”, and only needs to be performed once for each phone.
Page 4
Headset to this phone. ATTACHING THE HEADSET TO YOUR EAR Attach the Headset to your ear using the Ear-Loop. Insert the pin of the Ear-Loop to a suitable depth so that the speaker fits snugly into your ear (hovering above your ear canal), then bend the flexible bow of the Ear-Loop to produce a snug but comfortable fit.
Page 5
Press the Wheel steadily for at least 3 seconds Short press the Control Button NOTE: Wait until you hear the incoming call on the headset (not only on the phone) before pressing the Control Button Long press the Control Button Short press the Control Button Move the Wheel up by steps.
Lock/Unlock buttons BATTERY MONITOR To check the status of the headset’s battery, press the Control Button for at least 7 seconds while the headset is on Standby position. The Status Light will flash for 2 seconds as follows: • Blue •...
Page 7
NOTE: The headset will revert to its default right ear configuration once it is turned off. In order to regularly use the headset in left ear configuration, always turn on the headset using the Control + Wheel procedure above.
LOCATE THE HEADSET (Buzzer Function) The scala-700 allows you to locate the headset by activating a buzzer. Activate the Buzzer as follows: Dial a call with the mobile phone and press Send/Talk. While the call is in progress, begin pressing the mobile phone volume buttons up, then down, repeating the up/down sequence four or more times.
Locate the headset TROUBLESHOOTING Note: For most problems, it is recommended as a first step that you turn the headset off for 20 seconds and then on again. If this does not help, try pairing the headset and phone again. Problem...
Page 10
Battery does not provide at least six hours of talk time. Voice Dialing) : 1. Make sure your headset is turned ON and in standby mode while the blue light indicator flashes slowly. 2. Verify that the Bluetooth function on your phone is set to ON.
Page 11
2. Disconnect the Charging Jack, wait a few seconds and plug it back in. 3. When the headset is fully charged, the red light turns off. 1. Possibly caused by nearby interference 2. If you have a GSM phone and your headset is too close to the phone, interference may occur.
Page 12
SUPPORT We strongly suggest that you download from our website the most updated version of the comprehensive User Manual. For additional information visit our website at www.cardowireless.com, or call us Toll-free USA: 1-800 488-0363 Europe: +49 89 450-36819 Developed and Manufactured by: w w w .