Unpack the Printer
Carefully remove all items from the box.
and Software Kit
Photo Paper Tray
i 960 Series Print Head
BCI-6PM Photo Magenta
BCI-6PC Photo Cyan
Prepare the Printer
Remove the shipping tape from the
front and back of the printer.
Plug the power cord into the back of the
printer and connect the other end to a
Press the POWER button. The printer
Open the front cover. The print head holder
automatically moves to the center. Remove
the protective tape.
Write down the serial number located to
the right of the print head holder. You will
need this later to register the product.
Easy Setup Instructions
Install the Print Head
Remove the print head from its package.
Tear at notch to open
Remove the orange protective cap
from the print head nozzles.
NOTE: Do not touch the electrical contacts
or the print head nozzles.
Print Head Nozzles
Raise the lock lever on the printer.
Slide the print head into the holder.
The print head will rest at a slight angle.
Lower the lock lever and press it down
until it clicks into place.
Install the Ink Tanks
Peel back the orange tab and completely
remove the plastic wrapper from the
Magenta Ink Tank (BCI-6M).
Twist off and discard the orange
NOTE: To avoid spilling ink, never
press on the sides of an ink tank.
Insert the ink tank into the correct slot.
(Refer to the color guide on the print head holder.)
Press down until the ink tank clicks into place.
Insert the remaining ink tanks into
their assigned slots.
Close the front cover and extend the
paper rest and paper output tray.
Paper Output Tray
NOTE: The printer will perform a print
head cleaning after the cover is closed.
Connect the Printer
and Load Paper
IMPORTANT: Be sure the printer is
off before continuing, or the computer
will attempt to install the printer
driver before the printer is ready.
TURN THE PRINTER OFF.
Connect one end of the USB cable
to the computer, the other to the
appropriate USB port on the printer.
If your computer and operating system
support USB 2.0 Hi-Speed, use the
top port. Otherwise, use the bottom port.
960 Series Photo Printer
is equipped with both USB 2.0 Hi-Speed
and USB 1.1 ports. If you do not know
your USB version number, connect using
the lower port.
Do not switch port after installation.
Pinch the paper guide and slide it to the left.
Load a sheet of blank paper in the paper
rest. Slide the guide toward the left edge
of the paper.
Continue with Step 6
on side two.