Error Messages In The Status Monitor - Brother HL-2140 User Manual

Error messages in the Status Monitor

The Status Monitor will report problems with the printer. Take the proper action by referring to the following
table.
The default setting for the Status Monitor is off. If you want to turn the status monitor on, follow these steps:
®
For Windows users
Start All Programs
Click the button,
1 ®
Programs for Windows 2000 users
®
For Macintosh users (Mac OS
Status Monitor (For Mac OS
See
Error message
Cover is Open
Memory Full
Print Overrun
No Paper Fed Tray 1
1
, your printer (e.g Brother
®
X 10.3 or greater only)
®
X 10.3 or greater users) on page 44
Action
Close the front cover of the printer.
Press the Go button to print the remaining data in the printer memory. Cancel the
print job if you want to delete the remaining data in the printer memory. See Go
button on page 55.
Reduce the complexity of your document or cut the print resolution.
Press the Go button to print the remaining data in the printer memory. Cancel the
print job if you want to delete the remaining data in the printer memory. See Go
button on page 55.
If this does not clear the error, reduce the complexity of your document or cut the
print resolution.
(HL-2150N / HL-2170W only)
Change the following settings in the supplied Windows
best combination of these settings will vary depending on your document:
1
• Graphics mode
1
• TrueType mode
• Use Printer TrueType
1
Choose the Advanced tab, click the Print Quality icon, and then choose Manual in Print Setting
and click the Setting... button.
The paper tray may be out of paper or not properly installed. If it is empty, put a
new stack of paper in the paper tray and then press the Go button.
If there is paper in the paper tray, make sure it is straight. If the paper is curled,
straighten it before printing. Sometimes it is helpful to remove the paper, turn the
stack over and put it back in the paper tray.
Cut the amount of paper in the paper tray, and then try again.
Make sure you use paper that meets Brother's recommended paper
specifications. See About paper on page 5.
Load the same size paper that you selected in the current driver setting.
HL-2140 Status Monitor
), and then
.
® 1
Fonts
Troubleshooting
.
®
driver and try again. The
80
6
6