Error Messages In The Status Monitor - Brother HL HL-1270N User Manual

Error Messages in the Status Monitor

The Status Monitor will report problems with the printer as defined in the following table.
Take the corrective actions for the error message that is suggested in the Status Monitor
reports.
Error Message
COVER OPEN
NO PAPER or
MISFEED
PAPER JAM
TONER LOW
TONER EMPTY
PRINT OVERRUN
Action
Close the front cover of the printer.
The paper cassette may be out of paper or not properly
installed. If it is empty, load a new stack of paper into the
paper cassette.
If there is paper in the paper cassette, make sure it is straight.
If the paper is curled, straighten it before printing. Sometimes
it is helpful to remove the paper, turn the stack over and place
it back in the paper cassette.
Reduce the amount of paper in the paper cassette, then try
again.
Make sure you use paper that meets Brother's recommended
paper specifications.
Chapter 1.
See "PAPER JAMS and how clear them".
Purchase a new toner cartridge and have it ready for when the
Toner Empty status is indicated.
Refer to "How to replace the Toner cartridge" in Chapter 3
view the instructional video on the CD-ROM.
Press the panel button to print the data remaining in the
printer.
If this does not clear the error, reduce the complexity of your
document or reduce the print resolution.
Expand the printer memory by adding a commercially
available SIMM. See "How to add extra Memory" in Chapter
2. Set page protection to ON by using the supplied Windows
driver or RPC program.
Change the following settings in the supplied Windows driver
and try again. The best combination of settings below will
vary depending on your document.
Graphics Mode
TM
True Type
Use Printer True Type
4-6
See "What kind of paper can I use" in
mode
TM
Fonts
or