Wireless Setup Problems - Brother NC-2200W Network User's Manual

Wireless Setup Problems

The NC-2200w is not found while setup by the Wireless Setup
Wizard
Make sure that the Link LED is turned on. If the Link LED is not
turned on, Brother NC-2200w may not work properly. Check the
following:
1
Check if the Brother NC-2200w power is turned on.
2
Check if the Brother NC-2200w is securely connected to the
Brother Printer/MFC/DCP and the Printer/MFC/DCP is powered
on.
3
Move your PC closer to the Brother Printer/MFC/DCP with the
NC-220w installed and try gain
4
Reset the NC-2200w back to the default setting and try again.
For the information how to reset to the factory default setting,
see Test Button on page 1-4.
Before you configure the NC-2200w, you need to temporarily change
your computer's wireless settings to communicate with the un-
configured NC-2200w. Check following:
1
Check if the wireless settings of your computer are as follows.
Communication mode: Ad-hoc (channel 11)
Network name (SSID/ESSID): SETUP (case sensitive)
Encryption
2
If you are using Windows
greater, and the Ad-hoc network "SETUP" doesn't appear in the
available network list of the wireless setup utility of the
®
Windows XP or Mac OS
problem by manually adding the Ad-hoc network using the
following procedure.
: None
®
XP or Mac OS
®
X, you may be able to resolve this
®
X 10.2.4-10.3 or
TROUBLESHOOTING 6 - 2