Behringer ULTRA VIBRATO UV300 User Manual

Thank you for showing your confidence in us by purchasing the BEHRINGER ULTRA
VIBRATO UV300. This high-quality effects pedal delivers the classic pitch modulation
and dimensional vibrato effects of the '60s and '70s. Its comprehensive controls allow
you to tailor the UV300 performance right for your needs.
The MODE switch changes the functionality of the effects pedal footswitch.
When set to LATCH, the effect will be activated/deactivated by pressing the pedal
once. When set to UNLATCH, the effect will only be active if you depress the
pedal. The BYPASS mode can be selected when no vibrato effect is required. The
input signal remains uneffected even if the pedal is depressed.
The RISE control adjusts the time needed for the effect to reach its maximum
detuning. Modulation sets in more slowly when it is turned clockwise.
The RATE control determines the speed of the vibrato effect.
The DEPTH control adjusts the intensity of the pitch modulation effect.
The ON/BATT LED illuminates when the effect is activated. It also serves as a
battery level indicator.
Use the footswitch to activate/deactivate the effect.
Use this 1/4" TS IN connector to plug in the instrument cable.
The 1/4" TS OUT connector sends the signal to your amp.
Use the DC IN connection to plug in a 9 V power supply (not included).
The BATTERY COMPARTMENT is located underneath the pedal cover. To install or
replace the 9 V battery (not included), press the hinges with a ballpoint pen and remove
the pedal cover. Be careful not to scratch the unit.
The UV300 has no on/off switch. As soon as you insert the plug into the IN
connector, the UV300 is on. When not in use, remove the plug from the IN
connector. This extends the life of the battery.
ULTRA VIBRATO UV300
1. CONTROLS
Top view