Behringer SUPER METAL SM400 User Manual

Thank you for showing your confidence in us by purchasing the BEHRINGER SUPER
METAL SM400. This high-quality effects pedal enables you to produce super thick, tube-
like distortion plus endless sustain. Thanks to its high-performance features you can
achieve the typical hard rock or heavy metal distortion sounds.
The LEVEL control adjusts the output level.
The LOW control allows you to boost/cut the low-frequency range.
The HIGH control allows you to boost/cut the high-frequency range.
The DIST control adjusts the amount of distortion effect and the length of the resulting
sustain. High distortion settings will allow for extremely long sustaining tones.
The ON/BATT LED illuminates when the effect is activated. It also serves as a
battery level indicator.
Use the footswitch to activate/deactivate the effect.
Use this 1/4" TS IN connector to plug in the instrument cable.
The 1/4" TS OUT connector sends the signal to your amp.
Use the DC IN connection to plug in a 9 V power supply (not included).
The BATTERY COMPARTMENT is located underneath the pedal cover. To install or
replace the 9 V battery (not included), press the hinges with a ballpoint pen and remove
the pedal cover. Be careful not to scratch the unit.
The SM400 has no on/off switch. As soon as you insert the plug into the IN
connector, the SM400 is on. When not in use, remove the plug from the IN
connector. This extends the life of the battery.
The SERIAL NUMBER is located at the underside.
SUPER METAL SM400
1. CONTROLS
Top view