Behringer SPECTRUM ENHANCER SE200 User Manual

Thank you for showing your confidence in us by purchasing the BEHRINGER SPECTRUM
ENHANCER SE200. This miracle box enhances the sound of almost any instrument by
emphasizing the instrument's tone spectrum.
The BALANCE control adjusts the relation between direct and effect signal.
The SPECTRUM control adjusts the center frequency of the range that will be
emphasized from 500 Hz to 5 kHz.
The ON/BATT LED illuminates when the effect is activated. It also serves as a
battery level indicator.
Use the footswitch to activate/deactivate the effect.
Use this 1/4" TS IN connector to plug in the instrument cable.
The 1/4" TS OUT connector sends the signal to your amp.
Use the DC IN connection to plug in a 9 V power supply (not included).
The BATTERY COMPARTMENT is located underneath the pedal cover. To install or
replace the 9 V battery (not included), press the hinges with a ballpoint pen and remove
the pedal cover. Be careful not to scratch the unit.
The SE200 has no on/off switch. As soon as you insert the plug into the IN
connector, the SE200 is on. When not in use, remove the plug from the IN
connector. This extends the life of the battery.
The SERIAL NUMBER is located at the underside.
SPECTRUM ENHANCER SE200
1. CONTROLS
Top view