Behringer FLANGER MACHINE FL600 User Manual

Thank you for showing your confidence in us by purchasing the BEHRINGER FLANGER MACHINE
FL600. This high-quality effects pedal delivers 11 extraordinary flanger modes with extensive parameter
control that allow for maximum creativity so you always have the best sound regardless of the situation.
The TYPE switch lets you choose between a high-fidelity, DIGI(tal) flanger with a flat frequency
response, a vintage-type, ANALOG bucket-brigade delay with filtered frequency response and a
classic studio flanger from the '70s (TAPE).
With the TIME control, you can adjust the flanger delay time. Longer delay times produce a
sharper, more detuned sound, very close to a chorus effect.
The SPEED control determines the speed of the flanger effect. In CHORUS, VINTAGE, SINE,
SAW UP and SAW DOWN modes, turning this control to the MIN(imum) brings the LFO to a halt.
The F.BACK control determines the amount of output signal fed back into the flanger input in
order to confer more or less intensity to the effect.
The blue ON/BATT LED illuminates when the effect is activated. It also serves as a battery
level indicator.
Turn up the DEPTH control to achieve a fuller and deeper effect sound.
This control lets you choose between different flanger effect modes:
TRG DWN: The modulation signal triggers a linearly falling wave envelope with a falling time
determined by the SPEED control.
TRG UP: The same as TRG DWN but with a linearly rising wave envelope.
CHORUS: The signal is modulated by a wide-range, triangular wave with a large offset producing
a chorus-like effect.
VINTAGE: A simulation of the classic MXR flanger.
RANDOM: A random value generator produces a modulation signal whose level varies with each
cycle of the LFO, which has a smoothing filter applied to the output.
STEP: The same as RANDOM but without the smoothing filter at the LFO's output.
SINE: The signal is modulated by a sine wave.
ENV UP: The flanger's delay time is modulated according to the amplitude variations in the input
signal as detected by an envelope follower.
ENV DOWN: The inverted version of ENV UP.
SAW UP: A positive sawtooth wave modulates the signal.
SAW DOWN: A negative sawtooth wave modulates the signal.
POL lets you choose between NEG(ative) and POS(itive) feedback flanger modes.
Use the two 1/4" TS connectors IN A and IN B to plug in a stereo input signal. For mono use
connect to IN A.
The two 1/4" TS connectors OUT A and OUT B send the signal to your amp. Use both outputs to
achieve a full stereo effect. For mono use, connect to OUT A.
In CHORUS, VINTAGE, SINE, SAW UP and SAW DOWN stereo modes, both channel signals
are processed with inverted phase LFOs. In SAW UP and SAW DOWN mono modes, both
delay lines are mixed to create a continuous rise/fall signal.
Press the footswitch to activate/deactivate the effect. Depress the pedal (>2 s) to set the flanger's
speed by tapping the pedal to the desired tempo. Depress the pedal once again (>2 s) to quit the
set tempo function.
Use the DC IN connection to plug in a 9 V power supply (not included).
The BATTERY COMPARTMENT is located underneath the pedal cover. To install or replace the 9 V
battery (not included), press the hinges with a ballpoint pen and remove the pedal cover. Be careful
not to scratch the unit.
FLANGER MACHINE FL600
1. CONTROLS
Top view