Sign in today to find solutions:

Forgot your password?

Don't have an account? Sign up

Behringer PMP2000 User Manual

Behringer europower pmp2000 mixers: user guide.

 
User Manual
Version 1.2
May 2007

Summary of Contents

  • Page 1

    User Manual Version 1.2 May 2007...

  • Page 2

    EUROPOWER PMP2000 IMPORTANT SAFETY INSTRUCTIONS CAUTION: To reduce the risk of electric shock, do not remove the top cover (or the rear section). No user serviceable parts inside; refer servicing to qualified personnel. WARNING: To reduce the risk of fire or electric shock, do not expose this appliance to rain and moisture.

  • Page 3

    Because we know that your success is our success, too! I would like to thank all people whose help on “Project PMP2000” has made it all possible. Everybody has made very personal contributions, starting from the designers of the unit to the many staff members in our company and finally to you, the user of BEHRINGER products.

  • Page 4

    1.1.2 Initial operation Be sure that there is enough space around the unit for cooling and, to avoid overheating, please do not place the PMP2000 near radiators etc. Before you connect the PMP2000 to the mains, please...

  • Page 5

    CD player or tape deck, for example. The CD/TAPE/LINE OUT RCA output provides the stereo main mix signal of your PMP2000 and can be routed to, say, a recording machine. When the CD/TAPE OUT signal is connected to a tape...

  • Page 6

    Blown fuses should only be replaced by fuses of the same type and rating. Use the POWER switch to put your PMP2000 into operation. The POWER switch should always be in the “Off” position when you are about to connect your unit to the mains.

  • Page 7

    Fig. 4.5: Loudspeaker connector Please be sure to only use commercial Speakon cables (type NL4FC) for connecting your loudspeakers to the PMP2000. Please check the pin assignment of your loudspeakers and cables dependent on the PMP2000 speaker output you choose.

  • Page 8

    5. WIRING EXAMPLES Fig. 5.1: PMP2000 as stereo amplifier (example) Please set the MODE switch for this application! Fig. 5.2: PMP2000 as double mono amplifier (example) For this application, however, please set the MODE switch to “MON/MAIN”! Fig. 5.3: Standard setup (example) to “LEFT/RIGHT”...

  • Page 9

    20 Hz - 20kHz; measured at preamp output. All channels: level controls in center position; EQ flat. Reference = 0 dBu. BEHRINGER is constantly striving to manintain the highest professional standards. As a result of these efforts, modifications may be made from time to time to existing products without prior notice.

  • Page 10

    All trademarks (except BEHRINGER, the BEHRINGER logo, JUST LISTEN and EUROPOWER) mentioned belong to their respective owners and are not affiliated with BEHRINGER.BEHRINGER accepts no liability for any loss which may be suffered by any person who relies either wholly or in part upon any description, photograph or statement contained herein. Colors and specifications may vary slightly from product.

  • Page 11

    (2) this device must accept any interference received, including interference that may cause undesired operation. Important information: Changes or modifications to the equipment not expressly approved by BEHRINGER USA can void the user’s authority to use the equipment. EUROPOWER PMP2000...

Comments to this Manuals

Symbols: 0

Latest comments:

×

Select the desired size and copy embed code

Copy your embed code and put on your site: