Behringer AES8024 Installation Manual

Digital i/o option

Download this manual

hank you very much for your choice to expand the possibilities of your ULTRA-CURVE PRO DSP8024/

ULTRA-DYNE PRO DSP9024 by adding the AES/EBU digital I/O.

Before you get started: Please disconnect the unit from the mains!

Remove the four Philips head screws from the rack ears and the screws from the cover (two on the top, two

on the back, one on left and right side each). Lift the cover of the unit.

Remove the four 3-mm screws that fix the small cover plate on the back of the DSP8024. Fit the two XLR

connectors here. They are mounted with two 3-mm countersunk head screws each.

Remove the jumpers, before you insert the interface board to the connector X19. Fix the I/O PCB using two

of the 3-mm screws you removed from the small cover plate.

Place the unit in front of you, so that you can read the printed labels on the board (display towards you).

Connect the DIGITAL INPUT plug to the three pin header marked "IN" (the connector next to the screw), and

the DIGITAL OUTPUT plug to the three pin header marked "OUT" on the AES/EBU interface board.

You can now close the cover and fix all screws again.

For detailed information concerning the operation of the AES8024 and the general warranty regulations

please refer to your DSP8024/DSP8024 manual.

The information contained on this sheet is subject to change without notice. No part of it may be reproduced or transmitted in

any form or by any means, electronic or mechanical, including photocopying and recording of any kind, for any purpose,

without the express written permission of BEHRINGER Spezielle Studiotechnik GmbH.

BEHRINGER, ULTRA-CURVE and ULTRA-DYNE are registered trademarks.

BEHRINGER Spezielle Studiotechnik GmbH

Hanns-Martin-Schleyer-Str. 36-38, D-47877 Willich-Münchheide II

Tel. +49 (0) 21 54 / 92 06-0, Fax +49 (0) 21 54 / 92 06-30

Installation Guide

Version 1.1

March 2002

www.behringer.com