B&K Reference 50 Owner's Manual page 68

A/v system controller
Table of Contents

Advertisement

From Remote
1
À(UP) or §(DOWN)
2
(LEFT) or
(RIGHT)
Set V1 line output usage - V1 output is normally set up as a tape loop. The V1 and Zone 1 (A) outputs are the
current source (V2, TV, CD, DVD, etc.) except when the current selection is V1. When V1 is selected as the
source, the Zone 1 (A) output is V1 and the V1 output is off. This prevents feedback when the V1 inputs and
outputs are connected to a tape deck or VCR. Feedback can cause high frequency oscillations, which may
damage your speakers. If you don't connect a tape deck to the V1 input and output you can use the V1 output as
an additional line out. In this mode V1 output is always the selected input including V1. Note: The Tape input and
output is always set up as a tape monitor for Zone 1 (A).
ADVANCED ZONE A SETTINGS
1 Max Level
2 Zone ID
3 On Screen Display
4 V1 Output
4 V1 Output
5 Surround Modes
6 Favorite Recall use
next item
MENU advanced setup
ZA V! OUT
From Remote
À(UP) or §(DOWN)
1
2
(LEFT) or
(RIGHT)
ADVANCED ZONE A SETTINGS
1 Max Level
2 Zone ID
3 On Screen Display
3 On Sreen Display
4 V1 Output
5 Surround Modes
6 Favorite Recall use
next item
adjust
MENU advanced setup
OSD
ENABLED
From Front Panel
(UP) or (DOWN)
VOLUME KNOB
+15 dB
1
User
Tape
Tape
Auto
ENTER
adjust
TAPE
From Front Panel
(UP) or (DOWN)
VOLUME KNOB
64
+15 dB
1
User
User
Tape
Auto
ENTER
Action
move to On Screen Display
set to All, User or Off
ADVANCED ZONE A SETTINGS
1 Max Level
2 Zone ID
3 On Screen Display
4 V1 Output
4 V1 Output
5 Surround Modes
6 Favorite Recall use
next item
adjust
MENU advanced setup
ZA V! OUT
LINE
Action
move to V1 Output
set for Tape or Line
+15 dB
1
User
Line
Line
Auto
ENTER

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents