Table of Contents
Advertisement
ITEM
Handset D-Kit #182835 (white)
Handset cradle
*
Thumbscrew
Handset K2G2
Handset cord H4DU
PJ327 Adapter
Power module KS22911 L2
400B2 Adapter
Power cord (7-foot 2-pronged D6AP87 modular cord)
*
This piece of equipment comes with the Handset D-Kit, but it can also be ordered
separately with the Comcode in the second column.
INSTALLING THE CALLMASTER VOICE TERMINALS
Note: Use the following directions for installing both the
CALLMASTER II and the CALLMASTER III voice terminals. The
CALLMASTER voice terminal cannot be wall-mounted.
Connecting the Line and Optional Equipment Cords
See Figure 3 for the location of the jacks mentioned below.
Lay the voice terminal face down so the bottom slopes toward you.
1
Plug the line cord into the line cord jack. Press firmly until you hear
2
the line cord click.
Press the line cord into the line cord routing channel, placing the cord
3
under the tab, and gently pull any slack from the cord to the rear of
the voice terminal.
Turn the voice terminal rightside up so that the faceplate is facing
4
you.
Plug the line cord into the modular wall jack. (Since the line cord is
5
7-feet long, your CALLMASTER voice terminal must be within this
distance from the wall jack.)
NOTE: You may also use a 14-foot line cord. To order this cord, see
''Orderable Equipment'' earlier in these instructions.
Orderable Equipment (continued)
*
*
*
*
10
COMCODE
107318438
847278603
847278611
107244352
105635429
407128354
405331711
104152558
102937620
Advertisement
Table of Contents
